Voice Systems and Accessories - Small Business

My setup / use case is the following: * SPA232D * Calls are placed via analog phone connected to the phone port * 2 SIP user ids and passwords at my SIP provider (didlogic) with different phone numbers * All directly dialled numbers (no #9 prefix) sh...

Can a Cisco SPA525G phone be used as a landline phone?

Hi All, Im currently experiencing an issue with a cisco ata 112. Its currently registered with the sip provider and works perfectly to make calls when connected to a telephone. the moment we have a fax connected to the line, it stops working. the fax...

I am used to a UC320, and migrating to a UC520 - This maybe a simple question to some of you, but this is foxing me, and I am not a command line expert by any means so please go easy on me! I have a mixture of SPA525G, SPA303, SPA504G & SPA501G phon...

Hi, I just purchased a used UC520W for home office. I reset to factory defaults by copying the factory config (UC520W-16U-4FXO-K9-factory.cfg) to the startup. I plug a PC into 0/1/0 (1st of the 8 POE Ports), and the machine is not reciving a IP from ...

Hi There Everyone, I am getting this output from a customers ATA - SPA112. Can anyone tell me what it means ? <3>Jan  1 00:00:05 aklpuk1SPA112 [17179569.416000] physmap-flash physmap-flash.0: map_probe failed<3>Jan  1 00:00:05 aklpuk1SPA112 [17179571...

Can someone upload an image file for a UC520?  I need to get one loaded on my device and Cisco won't give me access to download it. Thanks, Ken

Have recently upgraded to new Yeastar S50 PBX and two-way intercom no longer works on some of our SPA525G's (firmware 7.6.2). Vendor has remote connected and verified all settings on the PBX side. Yeastar say everything looks good. SPA525G configs a...

I recently switched Internet providers and I cannot get my SBA 504G to connect wirelessly to the Internet. I purchased this phone in November 2013 and I'm told that I no longer have Cisco support and that this is my only avenue to try and get someone...

I have inherited 2 Cisco SPA8000 ATAs.  No one seems to know what the administrative password was set to, so the only option I have at this point is to perform a factory reset. Enter the instructions to connect and analog telephone, hit ****73738#1# ...

Dear Friends, I am confused about giving a solution for a call center setup, Requirements as follows, 1. Total IP Voice Phones 1800 2. Total IP Voice + Video Phones 150 3. PRI Connectivity 128 channels ( 4PRI) I wanna give them a solution, I  ha...

A few days ago my PAP2T stoppd working. Power led is showing below pattern (amber color): quick, quick, quick, slow, slow, slow, quick, quick, quick (3Q, 3S, 3Q). Connected phone has no signal, doesn't respond to **** Any ideas what has gone wrong?

There is remote control API avaiable on every phone on http://<ip>/CGI/ExecuteIt allow remote user to order the phone to dial any number, you can simulate key press, e.g. you can change anything accesible via phone menu and so on.Such API is open by ...