VPN

This is the routing table of are VPN_ASAroute outside 0.0.0.0 0.0.0.0 20.90.21.1 1route inside flair 255.255.255.255 172.18.0.1 1route inside 20.110.208.0 255.255.240.0 172.18.0.1 1route inside 20.110.216.0 255.255.255.0 172.18.0.1 1 route outside 0....

HI , I have set a tunnel between Cisco pix 6.3 and Cisco Router 7200. Show Isakmp sa showing below detail on Pix Total     : 1Embryonic : 0        dst               src        state     pending     created    xx6.x71.x29.x68   x2.1x7.52.1x1    QM_IDL...

Hi,We have a cifs share to a user shared drive, where every user has a personal folder.  How do you lock this down so that each user can only see their own folder?  At the moment everyone can browse and open anyone else's files/folders.Thanks in adva...

Hi,I am very new to Cisco routers and IOS so please excuse any ignorance on my part, we are a small start up and I am a make shift sysadmin. We have purchased a Cisco 892W router to provide a fixed VPN tunnel to our VPC hosted by Amazon. The router s...

Iam configuring Site to Site tunnel between ASA 5505. My topology:   10.77.59.0 ==Lan==|ASA1|=========|ASA2|==192.168.1.0  and  One more tunnel bw 192.168.1.0==|ASA2|=====|Draytek|==192.168.16.0   Both the tunnel is up any from inside PC i can ping a...

I am using a cisco asa5520 and i have set up remote access vpn with an AnyConnect connection profile.In the connection profile i have set up that users should authenticate using both certificate and AAA.Due to a high security requirement, the user ce...

I have a site to site VPN. On my hub router I am seeing the following message EVERY minute in the log!%sys-6-stacklow: stack for level DMA/Timer Interrupt running low, 36/9000I have been trying to figure out what the DMA/Timer Interrupt is and what i...

We currently have a couple of IPSEC SPAs that we are using to terminate site to site vpn tunnels in vrf mode.  We are looking at leveraging this hardware to also terminate remote access vpn using PKI to avoid the aggressive mode security issues.  I w...

Hello,Does anyone know if it is possible to run a point-to-point GRE tunnel over the GETVPN technology?TIADave

I have an ASA that I've set up for remote access.  The VPN group I'm using is "companyVPN".  The VPN client connects and I can see the Client-to-ASA traffic crossing the tunnel because the client shows packets being encrypted and the ASA shows them b...

Hi.I am trying to implement auto qos via radius on the LNS depending on the negotiated sync speed for ADSL. RFC2661 AV type 24/38 seems to be the way to get the sync speed value from the LAC.Anyone knows how to get this?

Hello all, I am tryingto replace a VPN3000 with an ASA (8.4) for remote access. We use Cisco ACS for authorization and accounting, and RSA for authorization.On the VPN3000 we were able to pass the Split-Tunnel list to restrict users access to only sp...

Hello all,This is my first post on a forum so bare with me Here's my setup.Site A:  1811 with ipsec VPN to Site B and Site Cinside 192.168.100.0 /24Site B:  1811 with ipsec VPN to Site Ainside  192.168.10.0 /24Site C:  1811 with ipsec VPN to Site Ain...