VPN

Many Kudos to the person who figures this one out...We have a VPN concentrator and about 15 1811's already in the field and working. We can't seem to get the latest one to work properly, we initially thought it was bad hardware, we are on our 3rd VPN...

Hi i am trying to implement a site to site VPN on a 1841 to a linux Debian.I can get the VPN to work but no traffic is going into the tunnel. Please help i have attached a copy of the config.Thanks.

Hello, Quick question.Cant seem to find the option. Using Security Device Manager for Cisco 1841 router and trying to find option to set the maximum Session Timeout. It disconnects now before 20 hours if there is activity or not. Thanks for the help!

I ordered and had two people verify I have the right license to upgrade two of the Interfaces on my ASA5510 to GiGabit.I installed the license key and reload and then did a power off still the ASA doesn't allow me to change the speed on any interface...

Hi all,I'm willing to configure a VPN client on my 2691 router [run IOS ver. 12.4(15)T7]. the network setup is quite simple, as following ADSL router --> VPN routerI've configured a loopback 0 to terminate the VPN sessions but to no avail, for curios...

Dear all.I have a site-to-site VPN across the internet forming a WAN connection (1 Mbps) between two sites. On one end I have Pix 515 firewall and on the other end I have an ASA 5505. Is there any form of data compression that can be enabled on the P...

Hi All,I have couple of ezvpn hardware cleints ( ASA5505) clients connects to VPN3000 at central location.5505 got base license and basic ezvpn configs. Please see below..********************************Licensed features for this platform:Maximum Phy...

Hey All,I have an issue if I try to add a mapping on my ACS box to generic ldap it fails after 4 minutes. I changed the server timeout on the ACS to 5mins(also 7mins) and it still times out after 4mins (is the server timeout just for authenticating u...

Hi, all, I am working on a project to enable multicast for home workers. Most employees have 851W at home and run ezvpn to headquarter ASA. Since ASA does not support DMVPN/VTI therefore mulitcast is not possible, so I plan to move ezvpn headend to a...

Hi.After creating a LAN2LAN VPN OR a VPN client connection, of couse, an access list is created. One entry for the access list is for the NAT0. In the line shown below, it is for the VPN CLIENT IP POOL. My question is WHY whenever I do a 'sh acces...

Hi,We have a ASA 5505,Requirement:We have two broadband with static ip, we want to implement failover mode if one connection goes down second one take the load automatically.We want ipsec tunnel to access remote subnet from local LAN thru internet.is...

I have a 5520 configured with 1 interface on a DMZ network. The management interface is connected to the internal network. Could someone tell me where I can find a write-up on cisco.com that explains how to configure VPN remote access. I am running i...

I want to enable VPN access on my cisco 2621 router but I am getting error message.

I really hope somebody can offer a decent reason why there is no VPN client for 64 bit Vista that supports IPSec. The floor is now open. If this has already been explained in depth, then please, by all means, point me to somebody who can explain th...