VPN

hi gurus,I would like to post a question regarding l2tp..Right we are having problem with l2tp's connectivity.The network elements involved are Nokia box(lac) and cisco 7200(lns).When a mobile user wanted to connect to corporate domain, using l2tp, s...

I used SDM to configure ezvpn on my 2811 ISR. My internal network is 10.1.28.0 and I set up the vpn pool to be 192.168.45.1-192.168.45.10After I apply the commands from SDM to the running config, everyone on my internal 10.1.28.0 network can't get to...

I just figured out that in order to configure VRRP between two 3030's, that the same code (4.7) needed to be on both concentrators. I could not find any reference to this is any release notes. Is there a doc out there that states this is mandatory ...

I understand that cisco has specified magin after which it declares a link connected accross two routers over utillised. Sometimes we have a Tx and/or Rx loads as high as 250. Could someone please help with percentage at least for a latency link.

Dear ALLThere is 2 routers, one is connected with internet, and want to use a aux and rollover cable to connect the second router's console, so that can telnet to 1st router and console the 2nd router.but what is the configuration of the 1st router? ...

Hi,I have a network with a 3660 on the perimeter and a PIX520 before my inside network. I want to allow external workers access to our network through VPN. I have read some documents and wanted to know - which is better to use a 3660 router or a PIX ...

Hi all,Im here because I need help with specific problem related to remote access. :)We have IBM server which we use to connect remote ISDN and dial-up users. All communication and authentication is done on this specific HW. But what we want is to se...

Hi,I am completely lost on this one.I have two sites that talk to each other over a DES vpn. One site on a MPLS cloud in the UK talking to a site in Luxemburg. The traffic is routed from the MPLS to my PIX on my site then encyrpted to Lux and vice ve...

I an new to the ASA and have experience with Pix. We presently have an established HUB and Spoke using Pix 501's. I purchased an ASA 5510, and have configured it as a Easy VPN Server. I can establish successful tunnels to all devices, the problem ...

All I am in the process of recovering a lost password from a 506e that was on the shelf. I have seen documentation via the cco site but I don;t have the ip info for the box to be able to determine the interface ip's. How may I perrforma a paasword ...

Hello,We would like to buy 2 "3845 security bundle with AIM-VPN-HPII-PLUS encryption card".We will activate the "stateful failover for IPSEC" functionnality.The routers will be connected to at least 50 sub-network (using sub-interface with encapsulat...

I have tried all read about reason 412 and I can't get VPN client to work. Open all ports found searching internet, disconnect firewall, install a later version, reinstall the program, try different internet connections (dial up and DSL)See log attac...

Hello. I'm looking for the best way to allow an external support company full access to only 2 of the servers on our LAN (i.e. no access to anything other than 2 particular IP addresses). They currently have full access via VPN client thru our Pix 51...

I have router 2801 , with WIC-1AM (analog modem), i connected the telephone line from PSTN to this modem,how to configure my router to use this Modem for backup connection ,the interface is: Async 0/3/0