VPN

Hi,I have 4-5 vpn server in production. I am unable to change password on these vpn server. I tried to reformat the flash with 911 thing, but it hasn't helpdes.What should be the next step?regardsRajiv

Hi forum,I am setting up a site-to-site VPN from a PIX506e to a PIX501. I am able to get the tunnel up and running successfully. I was hoping to use NAT-Traversal for the IPSEC session (i.e. encapsulate the ESP packets in UDP), but I can't seem to ...

Hi,I have the following topology, a Pix 515E with two ISP connection (2 outside interfaces) and this PIX will run OSPF and generate a defaul route.When I configured the OSPF all connections coming from the Outside2 couldn't reach the DMZ, but all Out...

I have cisco VPN client 4.6 on WinXP and the server is IOS easy vpn server (12.4T). Everything works fine with pre-shared keys, but when I try to use certificates for IKE authentication the VPN client never connects.In its log I always see the follow...

I'm using the Cisco VPN client ver 4.6.00.0045 to try and connect to a 3015 concentrator. This works fine from an ADSL connection but not from a 3G card. I've read various guides about setting up the Concentrator to work with the address provided by ...

I am configuring an 1803 for SDSL two wire for the first time and I could not find a good example config. Does anyone have a working config example for SDSL?Thanks, Meg

Hello All,I'm trying to configure a vpn connection to allow one of our vendors to connect to a server in the DMZ segment, Server A. The vendor's requirement is to have a site-to-site vpn setup. Their server (Server B) will connect to our Server(Ser...

Hi, I had a problem connecting one of my public static host using the VPN tunnel to another remote office. But another internal host was working fine via that tunnel. Can someone advice me on the problem?

I just need a litte clarification.My understanding is that different pvlan communities and all isolated vlans can NEVER communicate.Im not sure if this is true. let me put an example to show what i mean:PC A in community group A (192.168.1.1/24)PC B ...

hi,is it possible from a host in the inside to ping the interface ip of the outside of my pix? I just can't make this work.I can ping the inside interface but not the outside interface of the pix.I'm on the inside side.thanks.

I was wondering, if it is possible to create a one way Lan to Lan tunnel. like to only allow traffic that is initated from inisde the Network. Thanks for the help

Hi all,I need to establish a IPSec-VPN connection for remote users. Our setup is like that: internet -> VPN Con 3005 -> Intranet.Most of our servers are on the Intranet but users don't need access to all of them. So I tried to restrict access only to...

Is it possible to use 'tcp-udp' as the service type to list tcp and udp ports within the port-object subcommand? For example, I have pcanywhere 5631tcp and 5632udp and various of other ports i'd like to nest within one service group.And if so, what w...

Hi everybody, I am trying to get an SSL VPN setup on an ASA 5510 for a client. I can pull up the webpage for authentication from outside the network and authenticate properly, the client downloads and shows up as connected, but I am unable to pass an...