VPN

User under PIX501 could not connect to the VPN running on another site. It seems got connected to the server but failed while verifying the password. The error message says "Error 721: the remote computer did not respond". It looks like Pix blocks c...

Hello,I have an associate that's looking for a list of third party VPN devices that the PIX 506E is compatible with and has been tested with.Can anyone point to such a document?Thanks,Dave

Hello,My customer need to migrate from "Tacacs+ freeware version F4.03.alpha to Cisco Secure ACS 3.3.2 windows.Does there exist a script enabling me to export the users of the version "tacacs+ freeware" towards version ACS Windows ?Or a procedure for...

I am trying to setup a VPN between two 501e with the remote having a dynamically assigned address on the outside interface. I am unsure of how to do this. Any help would be greatly appreciated. Thanks

Hi, I got a PIX-515 run with faiolver funtion,and I found that the PIX cpu usage was 70% ~ 80 %,I check the interface traffic around 36Mbps,and the packet forwarding rate around 62M pps,I would like to verify is this the limitation of PIX-515E.Any re...

Can anyone point me to a link on Cisco's website on how to configure an IPsec VPN tunnel to multiple PIX spokes from a hub Router.We are replacing our PIX hub with a 2811 Multiservice router for the main purpose of allowing the spokes to commuicate v...

I have a point-to-point IPSEC-VPN tunnel between a pair of pix firewalls. I want to know if the fixup protocol works for VPN traffic? Specifically for FTP. Will FIXUP inspect FTP packets that travel over the vpn tunnel?

I have been trying to get my wireless lan adapter working for my Dell laptop so far have no luck ... help please

I have a customer that is trying to use a SIP based instant messenger, across a PIX based LAN 2 LAN VPN network. The PIXes are running 6.3.3. We can ping the SIP based messenger server, but when we start the messenger, we get a message about SIP unab...

Hi all,I want to know which memory is used to store theaccounted data for the below given configuration. [ip accounting output-packets]This configuration is done on a dialer interface.I have got this configuration on one of our Cisco2500 Router used ...

Hi all,is it possible reduce time when I call with analog dial-up to RAS server (with MICA modems installed). I spend about 45s when I call to RAS to connect and authenticate. Is over there some connfiguration command to adjust this time or any other...

Hello all,could someone explain me when analog to digitalconversation starts with connecting dial-up clientto digital MICA modems.My assumption is that only once when analog signalreachs nearest CO switch in PSTN which convertsanalog to digital. So s...

Hi all,I want to make a simple VPN with the IPSec Protocol between a router Cisco SOHO97 and a firewall Cisco PIX501 over the internet.Router#sh confUsing 1877 out of 131072 bytes!version 12.3!hostname Router!enable password xxx!ip subnet-zero!!no aa...

Hello ,I have using AS5400 and my users disconnected very frequently and the causes of disconnection are Lost of Carrier.I want to change the S10 register value from default 14 (1.4 second) to some high number like 50 or 70.I want to know how I do th...