VPN

Hi All, I'm fairly new to Cisco ASA so please excuse my naivety. We have a Cisco 5555 ASA which is currently configured for AnyConnect VPN via AD. The next step is to authenticate users/laptops with AD + Certificates.   I have configured the ASA as a...

Hello guys, I have Cisco firewall ASA 5505 (CLI:ASA Version 8.2(2); ASDM version: 6.2(5)). We had configure VPN (site to site) toward the customs agency. They sent me private LAN and settings  we to configure in ours firewall. The problem is: when we...

Hello!   We are preparing to implement a new DMVPN/PfR WAN for a customer, in preparation for their roll-out of VoIP.    For the best VoIP support, of course we would prefer to allow voice traffic to flow directly spoke-to-spoke.  However, the custom...

I'm working on a VPN site-to-site solution with VLAN on each site. Physical ports are manually configured for matching user role to VLANs. I would like that users stay dynamically in their own VLAN wherever they are connected from (internal or extern...

We want to create site to site VPN with one of our partner, our current setup is as below. We have three ISPs terminated on A10 load balanacer ----> Router---->ASA firewall Could any one help...

Hi All, We have two sites i.e. Primary and DR for SSL VPN. We are using Cisco Anyconnect client for SSL VPN. On desktop or laptop machine the Anyconnect client software gives the prompt to reconnect to the VPN in case of primary site goes down. Bu...

I have replaced the cables and the Cisco ASA 5505,  I still lose packets whenI ping a pc on the other end of the site to site IPsec vpn tunnel.  Can someonetell me if this is related to the configuration of Cisco ASAs or other networkingproblems.  Th...

Dears i confugre the below on my ASA     access-list ACL_PROXY_ACL extended permit ip 10.10.10.10 255.255.255.255 44.44.44.44 255.255.255.255 ! crypto ipsec ikev1 transform-set TSET_TO_BRANCH esp-aes 256 esp-sha256-hmac   ! crypto map CMAP_VPN 10 mat...

    Question : when I am trying to ping IP Loopback IP or Router 3 from Router 2 then i am unable to ping it. Even on router R1 unable to ping se 1/3 13.1.1.1/24.   Below are configuration or all three routers.   Router 1***********interface Loopback...

I am experiencing an issue with the 'show sessions' command. I wanted to test out the 'show session' and 'show users' commands just to see it work properly. However, after starting a Telnet session from one switch (SW1) through the default gateway an...

 Hi,   I have a query that i hope someone would be able to clear up and correct my understanding if wrong. We're currently running GETVPN over Hub/spoke MPLS. The branches/spokes currently have no access to the internet, however now there is a need f...

Hi Guys, We currently have 2 Datacenters, but for management we only have 1 AnyConnect entry. Now we're looking into bringing in some redundancy for our AnyConnect VPN and we found the Backup Server. Now i might be missing something here, but i couln...