VPN

I have a brand new pair of Cisco FTD virtual running v7.4.1 code.  When DAP is enabled with hostscan scanning look for Crowdstrike AV >= v5.0 and presence of Windows domain membership registry string, the Anyconnect client gets stuck at the "Please c...

Hi, My company is unwilling to set up split routing, for security reasons. Therefore, they ask us to disconnect from the VPN for bandwidth-intensive activities like VoIP and file downloads. This is cumbersome, as reconnecting requires us to input our...

HelloSo I configured my RA configuration on my FPR1010 for access to my LAN 192.168.5.0/24 but was curious how exactly would I allow this on my ISR to let me connect to it? Not exactly sure which Ports would be needed opened

After installed the Anyconnect on PC, PC cannot connect the WiFi and it will show error: Cannot connect this network

Which of the two manners is the proper way to start AnyConnect client on Linux?$ /opt/cisco/anyconnect/bin/vpnui$ sudo /opt/cisco/anyconnect/bin/vpn--$ /opt/cisco/anyconnect/bin/vpn --versionCisco AnyConnect Secure Mobility Client (version 4.10.08025...

Hello, We have a FMC with a pair of Firepower 2110 in HA. Because the certificate asociated to the VPN SSL trustpoint is about to expire, we need to renew the certificate. We issued the CSR to the client for get the new certificate but the client cha...

Hi, I have one issue with IPSec tunnel Lan-to-Lan between ASA 5525x (v9.8) and ASA FPR 2110 (v9.16). My Tunnel is up but ping between each client was not successful. Both peer status sh cry isakmp sa in "MM_ACTIVE".I ran packet-tracer icmp between pe...

Is there a way to verify VPN use and uptime?  I believe that the below command will only show output for the duration of the security association, which could be for an unknown time period.  Do you know a way to verify when counters were last cleared...