Wireless - Small Business

Hi all, I have 3xWAP4410N APs that I'm using to cover most of our warehouse.  Our neighbors right across the street have reported one of the APs flooding his AP with deauth commands. I'm guessing this has something with the rogue AP detection functio...

Good evening,i am trying to setup a VPN on WRVS4400N. the tunnel didnt come up, i used my public ip as the VPN peer and the LAN Private IPs on subnet 192.168.1.0/24 as the host IPs. After much troubleshooting, my client, that i am trying to connect t...

ok were using solarwinds network monitor and for some reason my WAP200E's are showing up as Tokyo Electric co devices and not cisco? Why would it be doing this?

Hello,i have three WAP200E, AP01 act as Master, AP02 and AP03 acting as repeater, all have the same last current Firmware.Repeating between AP02 and AP01 works fine, but repeating between AP03 and AP01 doesn't work successful. POE adapter of AP01 and...

My customer has about a dozen WAP200 access points. We are currently in the process of deploying IPv6 and we have hit upon a serious problem where the WAP200 forwards some untagged traffic from the ethernet into wireless SSIDs which should be bridgin...

Is there a firmware version that supports the N standard, not draft? The latest I see is 1.2.19 from Sep '09.  If not, can I use the WAP4410N latest firmware?Thanks.

FOR WAP4410N ACCESS POINT CAN CONFIGURE IN 4404 WLC

Hello everybody.Could someone help me with some deep technical questions regarding the AP541N access point?What I want to know is, if the AP has:- Watchdog per IP- ACK time adjusting- Site SurveyThank you all.Regards.Andrey Cassemiro.

Hi All,Anyone really good with WDS Bridging?  I'm trying to successfully understand how WDS Bridging works with all the SB Pro hardware I have, and to get it working optimally.  I have the following SB Pro hardware:1 x SA520W1 x ESW540 8P switch2 x A...

I tried to get higher speeds than 54MBits, displayed in Windows, which works without any problems for example on the D-Link DAP-2553, 130MBits are shown  doubleclicking the WiFi-Adapter after successful connection on my client.My client is an Fujitsu...

So we bought a couple of these to test out, with the intentions to replace some dead WRT54GL access points and get some N wireless setup.setup so far has been easy but I am worried these things are going to be a bugger down the road to manage.My main...

Hello,I have a Cisco WAP200 Wireless-G Access Point - PoE/Rangebooster with the latest firmware 2.0.2.4-ETSII’m trying to set it up as a repeater, repeating the wireless signal from a Cisco 877W.I have configured the WAP200 with the same SSID, WPA ke...

I wonder if anyone can help me. I have been going around in circles and not really getting anywhere with this.I have a D-Link DSL-320B ADSL2+ Ethernet modem that connects to the internet fine if I am using just 1 computer. However I have bought a Cis...

WRVS4400N v2.0 2.0.0.8QuickVPN 1.4.1.2Vista Home Premium SP2 64-bitTrying to connect from laptop through an AP to my WRVS4400N via VPN.  Not having much luck...I get to "Activating Policy..." and then "Connection Error"Here is what I have done:On rou...

Greeting all,I'm running a Cisco SMB Router included VPN (WRSV4400N), I have recently configured the VPN in my company's office and it works fine with all the devices connected directly on it.We are running an ESXi 4.1, and when i'm logged through th...