Wireless

Hello,we have a deployment of two WLC4402 (Version 6.0.196) with Mesh APs 1522 and AP1242 (Outdoor and Indoor).Two Questions:1) We control the Access-Point with a network management systems (Ping in regular intervals). Some times, APs are not reachab...

Hi,I have upgraded the WLC - 4402 from 4.2.130.0 to 4.2.176.0 after the upgrade all the AP's associated with the WLC has been disassociated and it never associate again with the WLC.  I have revert back the change to older version 4.2.130.0 but no ch...

Hi,  My customer wants to create guest users in wireless lan controller. We were successfully able to create that and it worked . But the problem is that to access the internet the users have to change the "proxy server" settings on the internet expl...

Folks,I have a doubt. I do have at present 4400-50 , which have 50 N-Access Points installed and it is full. This is deployed already. Now I need to add around 80 N-AP's . Can I propose 5508 series controller? Will it be compatible with existing 4400...

Hello  everyone,I installed for a client two  WLC4400 (one is used for redundancy). I wish I could make the aggregate links between these two  controllers to spread the load. In this configuration, there won't be primary and secondary controllers, AP...

Hi all,is it possible to create a VPN (or other something similar - like GRE) tunnel from any physical/logicel interface of a WLC (running OS 4.2.207.0) to a remote router? We'd like to tunnel the Usertraffic to a remote device to allow the user to a...

For one of my SSID's I am using 802.1x with WPA2/AES. I have configured IAS on windows server 2003 and from the server message logs I am able to authenticate a user. I never complete the authentication through the eyes of the WLC though. In using deb...

Hi All,Configuring a standalone 1250, and need to configure the management IP.  The management for the switch/access point are not the native VLan.  On a switch I'd just go "int vlan x  ->  ip address x.x.x.x"   But on an AP there is no such option, ...

Hi PushkarHi, I have an airespace 4012 and due to a mistake on the update it  caused that the equipment doesn't boot.I didn't take any copy of the firmware, where can i take this old  version from (version 2.0.142.0)? or is it possible to bring it to...

Has anyone used an NM-16A/S serial connection to a WLC 4400?I have my termial 'router' working with the rest of my Cicso gear and I would like to use it for my Wireless LAN Controller 4400. I tried to use the DB9 terminal connector that Cisco sends o...

My wireless network setup gotA WLSE and WDS with lots of Aironet 1210One SSID with MAC authentocationLAN and WLAN on same network We are in process of seperating WLAN and LAN by means of VLAN and want to retain the old setup for WLAN with a different...

Is there anyway to get the cert for my webauth off a 4404 controller. I would like to move it to another controller.

Does anyone know how to backup your controller config? I have templates saved my my WCS. Would sending the template out be the same thing as as restoring a backup of the config?