Hello Cisco members, I would like to ask if obtaining RSSI data from WLC controllers is possible, for associated and/or unassociated clients? I read some resources on the Internet which says it's doable via "Cisco Wireless Location Appliance", but in...
Forum Posts
Hi, We have a 2504 with HA sku and doesn't have a purpose for it and now we're thinking of re-purposing it. My question is, is it possible to install an AP adder license to a 2504-HA and will the HA in the sku go away after? Thanks in advance.
If the my RADIUS server connectivity is lost from the APs. What is the expected behaviour?It is documented for the cloud Meraki RADIUS server but knobs are given as well. But no such knob exists for my RADIUS server.https://documentation.meraki.com/z...
I'm currently working on a small POC to install OEAPs so our call center employees can work from home (ideally to bring a phone home with them and connect it to the OEAP POE port). We have softphones too but apparently management is still asking to m...
How can we make a C9300 switch act as a stand-alone for the 9800 WLC . In the documentation it says we can't act as stand-alone - is there a work-around / alternative?
My Customer use Cisco Prime Ver 1.4 U2it Background Task in Configuration backup is show failure all Device but I can Audit or syn config from WLC is success but config backup not success i need workaround prove issue ? Thank
Resolved! MRXX - Radio Numbers
Hi,Can someone please tell me what radio 0 is?We are attempting to tune our coverage, the event logs indicate power changes on radio 0. In radio setttings 2.4GHz = radio 1 and 5GHz = radio 2ThanksAdam
I have a single 3802i with CME 8.5.151. The wireless clients can ping their default gateway and any other wireless host. These same wireless clients cannot ping any non-wireless (aka wired) host on the same subnet. I've been looking through the co...
Resolved! WiFi design best practices
Was wondering if someone could give a second set of eyes on some WiFi Design. I’m at a location with multiple different switch stacks, each stack has a L3 IP scheme for ethernet, and a separate L3 IP Scheme for WiFi. I wasn’t around during initial i...
Since there is a boost in the number of MIMO. What is the maximum number of clients one can connect to these access points? Previously for MR52, I find that the sweet spot without compromising is around 65 devices. Any thoughts on this? Can i assume ...
Hi Everyone,We have about 12 laptop charging stations that have raspberry pi with wireless adapters integrated. Im having an overall large issue with connecting to the wireless. I will get "client has left AP" over and over. I was able to consistentl...
Hello.I have this issue. I connected many AIR-AP1852I-E-K9 and AIR-AP1852E-E-K9 (they need 20.9W) to different switches that provide 15.4W so I saw "PoE/Medium Power (15.4 W)" on WLC. To provide what my APs need I used a power injector but even after...
Hi all, The wireless setup in my work environment uses AIR-AP2802I access points and they are managed by AIR-CT3504 WLC.My endpoints are mainly microsoft surface pro notebooks and notice the wireless bandwidth on all these notebooks is capped at 173M...
Hi, I'm doing project for a large company who asked me to order a few Cisco Aironet 1815w APs. Now that I have them I don't know where to download the CAPWAP controller based software to configure them (I'm assuming it is a software app similair to w...
