Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I have an AP on my controller (3700i Aironet AP) lightweight showing its operational status as down. Further checks revealed the following as seen in the attached images; How do I enable the dot11 radio on the AP?

vezeh by Frequent Visitor
  • 2370 Views
  • 3 replies
  • 0 Helpful votes

Hello Friends, I have the brand new Air-AP2802i, which should have 256MB of flash memory. But when I am inside, and issue show flash command, I see only 57.5M (as attached). Where is the rest of flash? I have tried to install mobility express IOS,  A...

jbaros by Level 2
  • 7305 Views
  • 9 replies
  • 0 Helpful votes

I'm about to install a dozen AIR-ANT2566P4W-R Antennas on 3802e access points and the AP's have the connectors marked as A,B,C or D but I don't see any label on the cable or connector on the AP.  Does it matter which cable on the anntenna is plugged ...

Alex-Pr by Level 3
  • 9136 Views
  • 7 replies
  • 0 Helpful votes

I have a WLC5508 controller based in India that is servicing all of my EAME/AP sites.  Roughly 15 sites.  The most current site added was a new office also in India with (8) 2802i APs.  That office is connected to the controller site via IPSEC VPN us...

Greetings   I`m trying to configure LSC on WLC, everything goes OK before the moment when AP tries to establish DTLS connection with WLC.   Output from AP:   CAPWAP State: DTLS Setupdtls_disconnect: ERROR shutting down dtls connection ...CAPWAP State...

RDavidov by Frequent Visitor
  • 10991 Views
  • 6 replies
  • 0 Helpful votes

Resolved! Survey Mode

I connect a new MR30H out of the box to my home router, this then allowed me to access the local AP and set to survey mode. However, the power and channels will not change, if i change them, click save and refresh the page, they are still in default ...

Paul2469 by Community Member
  • 6851 Views
  • 4 replies
  • 0 Helpful votes

Last night we update WLC 5508 image 8.3.102 to 8.5.110, It,s update successfully and 3702 and 2702 Series LWP Download the latest image and working Fine but 1602 Series WIFI is not able to pick the latested image and stuck. Plz, find below log for be...

Vinay Bajpai by Frequent Visitor
  • 5706 Views
  • 3 replies
  • 0 Helpful votes

Hello, I am installing the new Cisco AIR-AP2802I, I have converted it to cisco mobility express to be a controller. I need to setup the tacacs here, but I am not able to switch it to Expert view. This option is not there. Kindly see attached. What sh...

jbaros by Level 2
  • 3076 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card