Wireless

Hi Guys,  What should be the power level of AP  ( CAP3502I-N-K9) having 5.4 Watts  / 41 dbm in the 2.4 Ghz and 5 Ghz ? Thanks

Hello, I have an AP 3702P with lightweight IOS when connecting to a Layer 3 switch,  it working well, but when connecting to Level 2 switch it doesn't work, the interface does not change to UP, and the interface of the switch is like unconnected. An...

Hello, we have a setup with multiple wap121, installed as stand-alone accespoints, no single-point setup, but all with same ssid. At a daily base we experience multiple disconnects. When a disconnect appears, all associated clients disconnect on tha...

Hello experts, Is that a problem to deploy VoIP on a flexconnect network ? I mean, is there a roaming problem is clients are roaming from 1 flexconnect AP to another flexconnect AP while the WLC is centralized on the HQ ? Reading the following, it ...

Scenario : 1.We have a Flat network with all the vlans configured on Core SW 3850 and one WLC 2504 for the APs and Default route towards Cisco ASA 5516-x for internet Connectivity. 2.Currently there are active 2 WLANs Mapping two different subnets a...

I need to capture the packets for Cisco jabber application in android phone. I used one App "tPacketCapture" for capturing the packets. But it didn't work properly since we are not able to make calls from jabber after enabling the tPacketCapture App....

Following from another (unanswered) question, I am still looking for information, debug or guidance why client numbers differ between WLC and CMX, CMX GUI and CMX API and more worryingly between different areas of the CMX GUI. WLC to CMX:  If I see ...

My network is working fine. i am also able to take GUI access of cisco 2702i standalone by directly connecting my laptop on the Switch Port and after manually configured eth port of my PC. but i am not able to take GUI over the wireless network even...

Hi, I know it's very common question, but I would like to ask if anybody was facing worst behavior of 5GHz in comparison to 2,4GHz mostly with very random disconnects. I wanted to get rid of 2,4GHz at all as all our laptops support 5GHz. So I have t...

Hi, We have to propose a wireless solution for a customer. He is interested in Meraki 33 AP. So, He has a warehouse that the height is about 10m. So, is the Meraki 33 signal strength will reach to ground ( length 10m - from roof to groud)? Thanks,...

Dear SirsI have some problem with VWLC(8.1.111.0) configuration in Flex+Bridge Mode by two LAP1262N  APs  and I have not found any proper configuration guide. There is a stable connection between Root And Mesh APs. On root side there is no problem an...