Wireless

Hi All, what is the maximum Number of Access Points on a Map in PI 3.4? Is there a hard limit, or Best Practice? I have to put between 200 -  300 APs in one Map, one Building with 20 Floors. The PI is working with MSE and CMX.   TiA, BR, Michael

Hi, I have 5 Cisco 1852 mobility express access points and have all been working fine. But in the last week 4 of the access points keep flapping between standalone and connected mode. I've tried rebooting the access points which join the controller b...

On troubleshooting we found that on core switch ARP will happen for all APs connected in LAN. I am getting ARP of all other APs but except one AP which has issue.  Interface VLAN of all AP is configured on core & AP is connected to access switch on a...

Hi All,   Can anyone tell me the basic difference between these images and which one i need to upgrade to and why?   Thanks

Hello Experts,   I have a requirement to completely replace Aruba outdoor deployment (around 190 APs) with Cisco (around 220 APs). However in order to facilitate this, the client has a requirement to facilitate smooth migration.  It is a possible opt...

Hardware used: Cisco WLC 5508Cisco LWAP AIR-CAP3502I-K-K9Windows Laptop This is what the topology looks like.   This is a complicated scenario involving ISE with the wireless services. The client can connect with the SSID, but no meaningful traffic i...

I recently installed an 8 AP (1832i) fabric connected to some 2960s. This install is one where I need to run 2 VLANs. Guest and Private. The Private VLAN 10 has a server on it which also acts as the DHCP server for the LANOn the Guest network, VLAN 2...

Hi,   Can anyone tell me if it's possible to move maps between buildings in PI 3.4?  I was convinced this was an available option but cannot seem to find it.   Cheers Neil  

Can you vMotion a Cisco vController while it is running?

Hello,   I'm trying to set RADIUS over IPsec between a WLC 5520 and Windows Server 2016. The RADIUS part works fine on it's own. My problem is I can't make the IPsec protion work at all. I have found an old guide but it seems that too many things hav...

I'm trying to set up an ethernet bridge using two 1572's, like this: WLC --- switch1 --- RAP - - - MAP --- switch2 The AP's are running in Flex+Bridge, the port on switch1 is trunked and all VLAN's are allowed. The WLC is running 8.2.100.0. I can con...

Team,  I  will be setting up a cisco wlan for guests and visitors on a cisco 2504 controller and my intention is to use port 3 or 4.   currently the wlc is configured to use ports 1 and 2( no LAG) for the current  wlans  and will be setting a new int...

Hi Experts, I could not access the APs even SSh/telent and web. The APs are managed by WLC. I can ping all of the APs but could not access all APs GUI mode also.   Please suggest me.