Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hi Which New/Latest AP models recommended to use with WLCs (8510/7500/5500) for better configuration and performance ? Thanks Karthi
Hai we have one customer with 5508 sso, its connected to two edge switches then edge connected to core all trunk ,core is the DHCP server.The issue is clients can get ip but no traffic pass outside gateway at core. no error logged. Tested different ...
Hi there, Trying to address this problem on a Mac - is it possible to change MTU from here? Trying to connect to VPN in another country. Thanks!
I have a requirement to provide Hyperlocation services for a new deployment. Idealy I would like to provide this using the later 3800 series access points, but it does not appear that the Cisco Hyperlocation module is supported on the 3800 series acc...
Can in configure captive portal in WLC2504.Please help me
What version of the WLC software do you suggest to install - 8.3.102.0(ED) or 8.2.121.0(ED)?
Hi, we are running a cluster containing 5 AP561, since today they are running firmware 1.2.1.3, before 1.2.0.2. There are per frequency 3 ESSID. On the main ESSID are up to 15 clients. Now i happens from each day some clients are unable to connect...
Resolved! Cannot configure AP device on Cisco WLC
Added new AP devices to our organization and when I try to add them on our 5508 Wireless Controller I get the following error:
Hi, I want to connect cisco 892-w AGN router Wireless WAN to hotspot so that my device at WAN side can reach internet. Purpose is i have primary link as MPLS and want this hotspot link as Backup
Hi All, At my workplace, we have a setup which contains Cisco 5508 WLC's currently running 7.6, mainly to enable us to use the 3702 access points. These work fine with our Prime Infrastructure device, which is running version 2.2.3. There is no upgr...
Hi, can anyone share the best practice configuration for Cisco flex connect for 8.2 image...
Hi, 1 AP 1 Channel 36 rssi- 86 AP 2 Channel 36 rssi -51 In the above case the client which is connected to AP will face slowness due to CCI when AP1 is talking to another client ? 2 AP 3 Channel 40 rssi- 62 AP 4 Channel 40 rssi -56 Thanks
I currently have a PID: AIR-CT5508-K9, VID: V03 And would like to have a second controller for the APs to fail over to. Do I only need to purchase the AIR-CT5508-HA-K9? I'm not sure what the VID V03 refers to... assuming its a version. Do I nee...
We have cisco 2500 series WLC with software version of 8.0.121.0. While configuring WlANS Layer 2 security as WPA + WPA2. There is no option of WPA2 encryption. Is it related to dtls encryption licesnse?
In a recent deployment this week we installed roughly 70 APs, two of which are not seen by the controller, Vlan tagging has been verified. I consoled into one and the complete logs are at the bottom of this. Here are some notable entries: *Mar 1 ...
