Wireless

Hi   in one Project i want change the password of Controller  for example username Administrator & password admin so it possible to change the Administrator password or first i have to create new user & new password then i had to delete the current A...

Hi to everyone. Yesterday I made the Using the MODE Button Follow these steps to delete the current configuration and return all  access point settings to the factory defaults by using the MODE button: 1. Open the access point cover (refer to the "Ho...

Hi everyone, I have several AIR-CAP2702E-B-k9 access points. this is a 4 antenna dual band ap as I understand it. we only want to use the 2.4G network and turn off the 5G part. can this be done?   thanks in advance.

dear friends...i am struggling with this devices now from some time.. not sure where is the mistake ...when i am trying to configure wireless device (AP) from web using exprerss setup or nornal manual mode .. it is not saving any changes.. means clic...

Hi Guys,Are all APs supported by Physical WLC also supported by the Virtual WLC? or they support a selective few?Thanks in AdvanceChandimal

Hi guys, According to Meraki documentation: As a wireless client roams in an area covered by Meraki APs advertising the same SSID, it will try and associate to the AP that provides the strongest signal. I have 4 APs in my office which are near among ...

New to the boards..    We have multiple AP units installed at the ceiling height. (30ft)  We have several "garage doors" that mobile units move through. The walls are 15 course brick with 15+' drywall - metal studs.  The units drop connection as they...

I have a few setups like this on our site, all run without issue and the speeds are good.  Basically we have a 1530 on each side using the 5GHZ antenna for the bridge link.  The 2.4 antenna is disabled.  These are standalone APs, not using a controll...

Hi Guys,   I want to create 3 SSID in WLC: 2 hidden SSID and one Broadcast. I want to let users to access through SSID broadcast and then when the user enter username and password then WLC switch these users intos hidden SSID...   Can i do this with ...

i have quite a no of unused 1200 11a AP, recently found out that i can take out the 11a module card from the AP.Question, can the Aironet 1200 runs in 11b after i have removed the 11a module and upgrade the firmware ?I found out that after i removed ...

Hi, For the last two weeks our 1852 AP's have been randomly rebooting. All AP's are connected to an 3850 switch. Nothing in the logs on the switch indicating any issue with power. We are unable to determine why these device's are behaving this way.  ...