Hello Experts, Have been going through the really helpful guide on VoWLAN deployment. There's an optional recommendation of disabling higher data rates (36-54 Mbps)for VoWLAN deployment. While the rationale behind the disabling of lower data rate...
Forum Posts
Hi , I am try for AP to join controller.Its not passing the join phase. AP is brand new AP (3802I) and controller is 5520 software version is 8.2 I am seeing discovery response sent after that its throwing below error *spamApTask5: Nov 18 13:56:59.1...
I'm currently registered with the 200-355 but then I ran across the other online. what is the difference between the two exams?
sir pls share cisco access point 1852e configuation steps.. pls share
Resolved! Code upgrade in WLC5500
Hi We are going to upgrade code from8.0.140.0 to 8.0.152.0 in WLC5500. I will follow the protocol below. but it looks like the document is a little older. Do you think so? And it mentioned boot image and primary image. What relation between the two i...
Hai I was installing brand new controller with AP 1852,but its getting disconnected often with errors also on wireless page AP ip not displayed
Resolved! CMX 10.4 - Location Based Policy Plans
We are setting up policy plans so that bandwidth is assigned on a zonal basis. We have VIP areas that will have higher bandwidth quotas than the rest. CMX communicates with the controller using only NMSP and SNMP read /write. So my question is how ...
HI My friends; What is the meaning of these logs? Is there any potential problem? Is there any solution? CST：%CONTROLLER-5-UPDOWN：Controller E1 0/0/0,change state to up CST: %LINK-3-UPDOWN: Interface Serial0/0/0:0,change state to up CST: %LINEPROTO-5...
Hi all, I am facing some issue with few Access Point . I am getting "Layer 3 discovery request not received on management VLAN" error in the AP join stats.These access point are running in flexconnect mode and located at remote location . I am onl...
Hello, Assuming that "Air Time Fairness" is on, how can I calculate the real bandwidth per AP per channel? Let's say we are on 5Ghz. Channel for N is set to 40Mhz, for AC is set to 80Mhz. GI is set to short. 4 clients are associated at 877.5Mb/s, 5 c...
i try to install the two 3502i access points to the virtual wireless controllerbut unable to join them to controller.the lightwieght image running on 3502i is " ap3g1-rcvk9w8-tar.124-23c.JA2.tar "need help and getting error *Jul 4 13:16:39.000: %C...
Hi, I installed a wifi repeater in the college's wired network to move from 802.3 to 802.11. My question is, Does installing such a repeater affect the network performance or make the network down?
Hi Any one can tell or provide a link to show the difference between AIR-CAP3602I-A-K9 and AIR-LAP1131AG-A-K9 Thank you
Dear networking collegues. I have a customer with Apple clients who wants to utilize mDNS and Bonjour spoofing on a WLAN. The issue is that the source of bonjour services is on the same vlan as Radius and SNMP management and thus cannot be directly c...
Hello,I would like to use mDNS AP to send mDNS packet to the WLC (source vlan are not visible to the WLC).I saw in the documentation that APs can either be in access or trunk mode to learn the mDNS packets from wired side and forward it to the contro...
