Wireless

Hello!I have received a new WLC2504 for my lab, which is nice....  What's not so nice is that I get a mysterious error message on the console. It appeared when the wizard started at first boot and it apperars at every startup since. I have gone throu...

I have a 2504 WLC with 3602 APs and have tried configuring FastTransition 802.11r but I am still suffering from disconnects using Skype, Viber, SIP when roaming between APs. Obviously, my limited knowledge in configuration is the problem. Can anyone ...

Hi, how can i change unit of measurement from feet to meters in MSE 10.2? thank you.

Hi, how can i change unit of measurement from feet to meters in MSE 10.2? thank you.

hello  i convert 1602i to lightweight but didn't join WLC 5508  the ap has IP  and it can ping the wlc  but the WLC cannot ping ap or i can't see the ap join stats  wlc : show sysinfo Manufacturer's Name.............................. Cisco Syst...

Team, Need a a technical support that says that the AP 2702 works fine with the power injector 5, eventhough in the datasheet the power injector recommended is the power injector 4. I have tested it, and works okey. Thnks!

Hi guys, i have a 1602 Aps in my organisation and 5508 wlc, the problem is that am facing weak signal coverage , 3 apS ARE INSTALLED AT A HEIGHT OF 30 FT due to which even if am standing beneath the ap only one signal bar its displaying. other aps a...

Hi,Can someone give me some documentation about the area coverage for Cisco Aironet 1700/2700/3700? ThanksSamuel

Trying to narrow down possibilities for an issue with 2504 WLC and airprint/time capsule.  Initially got the WLC unit in and 8.1 loaded.  Discovered nobody could use airprint.  Ran across a posting about cisco dropping some portion of support for bon...

We need a at least 20 ft extension cable for antenna 3G-ANTM-OUT-OM used on Cisco 819 router. Cisco link below shows two types of cables: LMR400 and LMR240. Which one should I buy for outdoor use? http://www.cisco.com/c/en/us/products/collateral/rout...

Dear All, we've installed some Cisco 1572 Outdoor APs but the signal bars are not consistent on both laptops and mobile phones and we're facing this problem for the users who are nearly in 10 meters of radius from the AP. please advise  BR

Hi How to enable band steering in wlc?

I was conducting a study on spectrum utilization around my managed network (100 LAP1142N APs controlled by a 4404 WLC). I gathered statistics of rogue APs via SNMP (object bsnRogueAPChannel [1]) and found that many rogue APs were detected in channel ...