Wireless

We are getting below errors frequently on Cisco 5508 WLC. These error messages started to came recently.*apfReceiveTask: May 03 09:43:44.180: #APF-3-LOCALHANDOFF: apf_mm.c:108 00:88:65:a9:07:24 0.0.0.0 DHCP_REQD (7) Unable to anchor locally*apfReceiv...

Hi, I have a Cisco WLC 5508 I am setting up and we are using it only for OEAP devices for home users. It seems that the OEAP devices (600 series and 1810) will only successfully connect if the management interface is the one that is internet facing. ...

Anyone know if it's possible to setup IPv6, LACP, or HTTPS/TLS certificates in Mobility Express? I can't find any of these settings on the web interface.

I have 4 1852i's. 1 of them has the mobility express firmware and is set as the controller. Internet works just fine. I tried joining 3 Lightweight 1852i's to this controller by going into the Software Update section of the master and loading the bun...

Hi, please can someone confirm that  the mode tunneling still exist in the controller mobility express ( 1852) as it was in lagacy controller 2XXX. in other words , still the packet data from wireless clients (laptops and smartphone ) pass through th...

I have purchased a Aironet 1620i wireless access point. Is this unit it's own lan controller? [email protected]

Hi, I Deleted about 100 AP on Prime by mistake. How can I get them back? I'm using Prime Infrastructure 3.0.0 and alla AP are "flex connect" AIR-CAP2702I-E-K9 added through WLC version 8.2.130.0 I tried to sync the controller but no more AP. I tried ...

CMX Location Analytics  feature is included in LIC-ENT-3YR and no extra hardware needed or licence needed ? or do i need this licence AIR-CMX-CLOUD?

if i use MR42 with Enterprise License and i need to make policy restriction based on users locations do i need any other hardware device or licence ?

Hi, Ny entire network uses the 10.0.0.0/24 range I have 4 Airronet AP1852I, 1 as a mobility express and the others as clients On the AP I have the management lan on the 10.0.0.0/24 range, and DHCP pool is setup to server from 10.0.0.200 to 10.0.0.254...

Hi everyone; I want to ask you dear forum user that how can i look the association log coming from client in wlc 5508? I look my syslog server but nothing. maybe my syslog level not contain what i want to see. My syslog level: Error. Thank you for yo...

Looking at enabling where clients on wireless and wired networks to be able to use mDNS service between each other.  Scenario - clients will be on wireless and wired - two VLAN s and different subnets . Same physical location / site  served by the sa...

Cisco 26000 wireless access point connected to lan can be ping and telnet but when I try to access via web-browser of we gui it fail. I have checked ip Http server configuration and get same result. Cisco IOS Software, C2600 Software (AP3G2-K9W7-M), ...