Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi dears ,I have 2 off 2504 wireless controllers ,each of them has respectively 50 and 75 AP license count. I followed https://rscciew.wordpress.com/2014/06/07/n1-high-availability-configuration-on-cisco-2504wlc/ guide for configuring it ,i guess I h...

hacizeynal by Level 3
  • 4150 Views
  • 21 replies
  • 0 Helpful votes

Hi, We use Flex Connect at our remote site APs. I would like to allow L3, client roaming between Flex Connect APs on different subnets.  Is this possible? And, what needs to needs configured on the controller side? Thank you, Pat

I  install one cisco AP 1832i version 8.3.102.0  for one customer .I have WLANs problem.There are 2 ssid in WLANS,one for employee and one for guest.employee is under  Management vlan (netwrok-192.168.0.0)and guest is under vlan 20(network192.168.20....

NLMK00007 by Community Member
  • 306 Views
  • 0 replies
  • 0 Helpful votes

In my scenario we have cisco 3850 switch also acting as a Wireless controller. Cisco IOS-XE software Sw version : 16.3.1 I need to configure my wireless controller 3850 switch to support wireless client authentication with Active directory server usi...

Hi  We have two controller flex 7510 and both are configured into HA with SSO. when i m checking the the log on the primary controller with command show logging last-reset  i can see very few messages. and when i m using same command on the secondary...

I have wlc type 5508 with version 8.3.102.0 and I am setting into a multi-domain, AP I use AP1572 type and status can join, but other types of access points here we use the type ap1552E status as a switch only join when I've upgraded to ios versio C1...

Dear All, I am trying to configure controller based AP but not AP is not able to appearing on controller. Upon power on of AP it appears on controller for a second or two and then disappears with following message errors. Regards, Muhammad Noman

I have an AP where I intend to have 2 ssid where each one accesses a different vlan. On the switch side I already have the trunk made with access to these vlans.However I can only get network in the AP when I access the native vlan ... When I try to ...

Nuno Galego by Community Member
  • 376 Views
  • 0 replies
  • 0 Helpful votes
Top Solution Authors
Review Cisco Networking for a $25 gift card