Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hi Everyone, I am trying to integrate an OVF MSE v 8.0.130 with Cisco Prime Infra, but i cant due to this error  "no response from server,it maybe unreachable or server is down or https server connection to server failed" attached are some screen sho...

Hi Everyone, I am trying to integrate an OVF MSE v 8.0.130 with Cisco Prime Infra, but i cant due to this error  "no response from server,it maybe unreachable or server is down or https server connection to server failed" attached are some screen sho...

Hello guys,  Before I start I would like to say that I am New to Cisco and never configure any access point or router before. I only used Linksys and TP link router and access point before. So please advise me as a new person.  I heard a lot of good ...

sonuwd by Community Member
  • 4544 Views
  • 5 replies
  • 0 Helpful votes

Just wondering if there's any way to adjust the columns in the web user interface on 8.0.133.0. Specifically, the Wireless tab has useless column widths that are IMO way too wide. I want to see how many users are on each AP, and this is a struggle on...

Hello everyone! I've configured Application Visibility in WLC 7.6 on 5508 controller and added Netflow export to Cisco Prime Infrastructure 3.1. In PI AVC Data Sources WLC appeared, but input flow record is showing less than 10 per 5 minutes, and i c...

Goga by Frequent Visitor
  • 839 Views
  • 2 replies
  • 0 Helpful votes

Hi I am looking for a MSE v8.0 deployment matrix that CLEARLY explains, not implies, the deployment options for MSE based on the services being deployed - CAS, wIPS and CMX - on either hardware appliance or virtual appliance. My focus is on MSE appli...

Hi board, I have CUWN base priciple question regarding the split MAC archtiecture. Because I guess my question is technically quite complex (from my point of view), I don't really expect an answer. However it's documented here and maybe some god-like...

Good morning i have a problem AIR-CAP-3702P-E-K9 after sending ip address AP LWAPP AP 172.16.1.62 ip address 255.255.0.0ping between:switch -ap -OKAP switch -OKyou can not get through a Web addresswhat I'm doing wrong ?? AP I also have no command: co...

Review Cisco Networking for a $25 gift card