Wireless

I am attempting to use my iPhone as a hot spot with my HP laptop.  I am using Cisco's AnyConnect to VPN in.  The laptop will not connect to the phone.  It says "Acquiring IP address" and seems to get stuck there. Laptop OS = 10 - 1607 wifi driver on...

Hi All, I have a POC MSE setup and i am trying to get this link to our customers Ekahau RTLS server. I have followed the documentation to setup the Context aware subscription notification. The connection to the RTLS server is not coming up though. J...

Hi, I'm trying to establish a connection between my Samsung S4 cellphone (with Android version 5.0.1) to a AIR-AP1242AG-A-K9 Access Point (with Software version 12.4(10b)JA). The AP is running a local RADIUS server with bob and hello as its username...

Hello, Reposted from Getting Started with Wireless: https://supportforums.cisco.com/discussion/13152826/887vaw-dhcp-server-not-working-wireless-clients I have tried to setup a 887VAW to have two vlans (USERS and MGMT) with both wired and wireless cli...

Hi, Does anyone know or have the information of supported RADIUS attribute for WLC? Like, session-timeout, accounting, authorization accept, etc. Thank you Regards, Arie

We have an aironet 1040 in one part of our building. It has been working without issue for quite some time. Just today, users started complaining that the wifi is extremely slow when using it through their iPhones. The users were extremely unclear bu...

Hi AllI am using C3850 catalyst switch load with IOS XE 3.7 / 15.2 doing switching and  built in wireless controller featureFor device management, Cisco Secure ACS doing the centralize authentication control  and user identity source is from Microsof...

In AP performance page, There is noise and interference showing for most APs. Please check attach file.

Hi, We are using WLC 5520 controller. But there is Interference and Noise showing For some APs which causes the poor connection.

Hello, I have a WLC 5520 with the software version 8.3.102.0 having a mobility anchor as 5508 WLC Controller in another location running with a software version  8.0.140.0. The 5508 is also configured as Internal DHCP Server providing DHCP Addresses ...

hi we have a vwlc in vlan 24 and prtg in vlan 13. we can t get any traps and there is no access list between vlans. both devices are connected with cat 6513. i tried a device connected to vlan 24 and i get snmp messages from vwlc. so the controlles s...

I,m trying to use DNS-based ACL with pre-authentication ACL, in order to allow access to some URL's before the client will be authenticate by external captive portal without RADIUSIn the bug search web, ( https://tools.cisco.com/bugsearch/bug/CSCup98...

I suspect this message after put command to Controller. Debug capwap errors enable It is normal message or problem ? Thank you very much