Wireless

Hi all wireless experts, I hope this is a correct group to post this question. I need to upgrade the existing wireless WAN from 3G to 4G, basically just swapping the 4G sim card with the existing 3G card. But after swapping the card, the new 4G wirel...

Dear Friends, Need Your valulable inputs to Design our New Wifi Solutions Our VP asked for New wifi solutions, which Never involves (Network team involvement) to provide guest wifi access to the visitors/ users when they are in our office. Just Like ...

I'm setting up a virtual wireless controller using the guide provided here: http://www.labminutes.com/wlc0001_vwlc_7_3_vmware_installation The narrator mentions your VMware being licensed for "Remote Virtual Serial Port Concentrator". I don't have a ...

Encryption is disabled on Cisco Aironet 2602 Access Point. What it will affect? Whether disabling is recommended?

I have two buildings within 100 meters. I called them and building A building B. Between buildings A and B is two audio channels and one data channel. In building B I need laptop/PC  with relevant software to store this data and forward on GSM  when ...

at my customer network wireless infrastructure, the cpu utilization always 0 % , is it normal for wlc ? thanks

I'm seeing very low throughput speeds for some users in my wireless network.  I'm currently using a 5508 controller with 2602e AP's (4 antennas attached).  I have no more than 16 users on a radio.  Tested speed vary from 45 Mb/s to less than 1 Mb/s a...

I have a 1262 in the USA and these are my active power levels by rate: AIR-AP1262N-A-K9 show controllers dot11radio0 show controllers dot11radio1 2.4GHz: Active power levels by rate 1.0 to 11.0 , 20 dBm 6.0 to 48.0 , 17 dBm, changed due to regulatory...

Hi all,I have installed dozens of WLCs but with this one customer rollout I have hit an impasse.  The customer has a 98% MacOS device environment running a 5508 HA pair and 3702i APs.  The Mac OSx users randomly lose access even when their device sit...

We've recently offered users free wifi to use while at work for streaming, browsing, etc...  I tested for a couple of weeks before go-live with absolutely no issues.  Since go-live, it has become so slow that it's unuseable.  They have a 50Mb/s circu...

I try to setup the network "rules" for my public WiFi network. This network should permit outbound TCP: DNS, http, https, pop3, pop3s, IMAP, IMAPs and UDP: DNS, NTP. Inbound none (only established stateful connections from the above list). Can this b...