Wireless

Hello,We have a Cisco WLC 5508 with v.8.0.100.0 as the image.  When we enabled sleeping clients to 720 mins., users still are asked to re-authenticate after their device goes to hibernate mode.  Can you please tell me what else we need to check or co...

Hi,We have a scenario where 5508 with HA is deployed in main HQ. This WLC is connected to Cisco 3750 through trunk port.There are multiple WLANs running and serving for HQ. Now there is a requirement where 10x 1602i WAPs are being bought by remote of...

Hello,I bought Access Points on Ebay.One Access Point still has a configuration on it, i am not sure if it is running in Lightweight or Autonomous Mode, but service password-recovery is presumably disabled.I can't get the Access Point to stop loading...

Hi, We have a couple of 2602e access points on which the led status is cycling through blue, green, red and off. In the data sheet it states that this message mean: Access point location command invoked. But i am not really sure what is means exactly...

Hi,I can see  redirect  url   has created  on the   wlc "https://isetest.test.com:8446/portal/gateway?sessionId=0a007c0a562357510001566e&portal=27963fb0-e96e-11e4-a30a-005056bf01c9&action=cwa&token=9dfdf8where iseservername.test.com  is fqdn  for the...

Good Afternoon,  A company I work for has gotten rid of all of their old Cisco AP's and I was wondering since the WiFi at my home is pretty horendous if it were possible to set up this AP as a Router to go along with a typical Motorolla Comcast Modem...

HelloWe are having issues with our Cisco Access points ( AIR-CAP2602I-E-K9 & AIR-CAP3502I-E-K9) that keep rebooting and downloading new image from WLC ( 5508). I have done some research sounds to me like a memory issue with the APs. When the AP reboo...

Hello,I have a laptop running Ekahau site survey, Inssider and windows powershell command netsh wlan show interface. Ekahau and Inssider tells me the RSSI level is -43dbm. Windows power shell command output tells me 84%.I have found the formula to co...

I'm trying to control our 2 spa-303 phones from the configuration utility. There's no problem with user access, but when I try the admin log-in, it's requesting a password. Problem is, we've only had the phones for 1 day, and I haven't set up a usern...

Hello,when a Flexconnect AP loses connectivity to the WLC, there's not service interruption.But what happens when the AP recovers the connection? I'm not sure, I need to repeat some tests. It seems that sometimes when the AP is reassociated to the WL...

Hi AllI have just bought a couple AIR-LAP1131AG-E-K9 AP's off e-bay to help with my CCNA Wireless studies, But i am unable to get thw AP connected to the WLC.the AP system software version is 12.4(10b)JA3. the AP is set up for DHCP and it obtains an ...

If you issue the show port summary command on a Cisco Wireless Lan Controller show port sum                                 STP   Admin   Physical   Physical   Link   LinkPr  Type   Stat   Mode     Mode      Status   Status  Trap     POE    -- ------...