Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hello, I was looking at buying an AIR-CAP3702I but do not want to buy a wireless controller for it so was wondering if it is possible to convert it into autonomous mode. I read somewhere that it is but you only get limited functionality? Regards,Davi...

As recently - we have found that the radio interface reset very frequently which has been happening several times within this month for one AP on average. Some of those (5 AP so far) got the radio interface down eventually and we need to  reload the ...

JESSEWANG1 by • Community Member
  • 2151 Views
  • 7 replies
  • 0 Helpful votes

How do who know about WLC5508 HA SSO pair both my BOX automatically. Because I have problem about when the power turn off the WLC will be turn off. I saw " show redundancy summery " the WLC cannot pair with HA Box after power turn on.If it power turn...

Has any one heard of a loss of wireless connectivity surrounding the use of Lync?  I have a few users who are experiencing partial loss of connectivity once they start using Lync.  Lync works fine but connection to email drops.  Any ideas?This is a C...

nh6we by • Level 2
  • 569 Views
  • 1 replies
  • 0 Helpful votes

When users connect to my companiees wireless, which authenicates using a Windows 2008 RADIUS server, they're prompted to accept a server certificate. I'd like to install a trusted SSL and prevent users from having to accept a cert every time they con...

Kevin Lotko by • Community Member
  • 1651 Views
  • 7 replies
  • 0 Helpful votes

I would like to set up a 5760 controller with a guest login portal (webauth) and limit the number of concurrent logins to just one for any given user.I see a lot of documentation and discussion about how to do this on the Airespace platform but not f...

xponet by • Frequent Visitor
  • 1400 Views
  • 2 replies
  • 0 Helpful votes

HiI got a message but I couldn't understand the problem. All assistance will be greatly appreciated. Syslog message generated from device : *%CAPWAP-3-INVALID_RET_CODE: 1 wcm:  Invalid result code 3. Failed to Process DTLS packet RegardsAngela

davisfu by • Frequent Visitor
  • 3996 Views
  • 4 replies
  • 0 Helpful votes

We have 2 5508 WLC's and @ 35 AirCap Radios.We're running latest S/W release 8.0.110.We presently use LDAP to authenticate to the wireless.We would like to move to LDAPS on port 636.Configuration Guide says you can select other port numbers for LDAP ...

Can Prime observe and monitor autonomous Bridges?I have 19 Bridge pairs, mostly 1410's, some 1310's and few 1232's I would like to have stats on..I tried a device discovery of a pair which completed successfully but I can't find the results.. Anyone ...

Hello, in  my WLC, in Controler, Interfaces, i have  10 interfaces (with 1 VLAN per interface) which are created, however, only one is 'Dynamic AP Management' Enable: the management interface.None of the other VLAN are routed to this WLC, i was wonde...