Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hello AllWe have a setup with over 2000 LAPs currently in a single VLAN/subnet spanned across sites. I suspect we'd be better off breaking this into smaller subnets but am trying to find a Cisco recommendation for the recommended number of APs per su...
I've been tasked with a project -- create a small 5Ghz-only WLAN/LAN for use within a convention booth space.The design uses one of the router Ethernet ports for connection to the dedicated Ethernet bandwidth input provided by the convention center u...
HI All, I have 2125 controller with running IOS 7.0.230.0, now unable to connect windows 8.1 laptops.It is support Windows OS 8.1 wireless clients, you need to upgrade the firmware to 7.0.250.X.. I think windows is latest version are supported or no...
Hi GuysLooking to deploy a new AP to vWLC controller, want to make sure I dont effect any users.. will adding a new AP to existing AP group cause all the AP's in group to reboot or only the new AP being added.Kind Regards
Hello, I want to know, even if the 2104 is EOS, if I can use it as a Guest Anchor with 5500 WLC ?I guess it can works but not supported. Is it right ?Do I need to run the same release for both 2104 and 5500 WLC to make it work ? Thank you.Regards,
We have both controller with AireOS release 8.0 and we are facing issues as after building the HA, the APs are unable to join. We have tagged management interface into the controller and the VLAN is tagged in the TenGigaEth interface in the distribut...
Hi,does anybody knows why an AP configured as spectrum doesn´t detect external APs?thanks for your help
Hello All,We have two autonomous AIR-SAP2602I-E-K9 APs. Is it possible to use MAC filtering with WEP or WPA? So devices trying to connect to the APs must use the WEP or WPA key and must be in the allowed MAC list.Many thanks for your replies.Abu
Hi, I got WLC working with server 2008 NPS will it work also with server 2012? Many thanks!
We are a Scottish Local Authority and have NCS prime system, 2 of 7500 controllers with 1500 AP's ; working in Flex connect mode. Our local NHS has NCS prime and 7500 controllers. We want to co-host an SSID anchored on the others system. I recollect ...
Hi Guys, I am trying to set up Cisco 5508 and the physical setup looks like this 5508 -> 3750 --> 3560 (POE) --> Access Point. When I try my pc to connect to a WLAN (few configured), it is getting connected but not getting any ip address. On windows...
Hi,I am experiencing hi delays and jitter over wireless network for wireless clients. We have part of our network still running standalone APs and part running WLC.On standalone, I am experiencing delays about 5ms to 20ms with a very low jitter (usin...
Hello! I've got a location with a 2500 Series WLC and 9 APs (mostly 1041Ns, but we've got two or three others) that we're trying to get AirPrint working with. I've tried enabling MultiCast, followed the KB article on enabling Bonjour for these devic...
What are upcoming issues if we installed WLC 2504 software 7.6.130 or 8.0 with Cisco 3700 access points?
Hi you all I got two WLC2504 and I need them in HA(primary controller and secondary controller HA-SKU). I already set them up like this:Primary controller 1)Dynamic, virtual and management interfaces2)WLANs3)AP Groups4) Wireless>Access Points>Global...
