Wireless

Dear Experts, We have configured ISE 1.2 in the distributed environment.so in the operation Authentication tab we are not getting any authentication logs.we have 1 admin node and aslo 1 PSN node and MN node.all the 3 nodes are up and synchronised  wi...

Can someone give me a simple explanation for why unique subnets would be necessary in a multi-site deployment when using WiSM?Are there any other situations other than WiSM where using unique subnets as opposed to a standardized scheme would be benef...

Dear gents,i have got 8 pieces of access point 4410nand i have a router 881 /k9 secI want to cover a building of 2 floors with this access pointswithout any cablesand i need to know how to make it ?what is the configuration ?

I am running a wireless network with about 130 AP's connected to a 8510 controller and using Prime for management.  I am trying to get AP utilization for an AP that is no longer connected and when I try to run the report Prime reports that it cannot ...

Hey guys-   We are currently running a Cisco WISM that manages roughly 500 AP's (1230) in Production today.  The Wireless environment equipment is now going to be replaced with 2x8510's for Production, 2x5508's as Guest Anchor WLC's for Guests, and A...

So basically I came into an environment where my predecessor had no formal IT training and apparently learned to run before he learned to walk, so some of the stuff he set up “works”, but there are issues with it. For example, the WLC Controller that...

I have a problem I get my wireless module is no longer open get just try 10.10.10.1, 2002 ... open does anyone know why?

I am in the process of deploying a whole bunch of Cisco AP to replace existing wireless infrastructure.  I have configured FlesConnect groups as all the AP's will share a same config.  Because there will be many AP's, I would like to preprovision the...

Hi Guys,I have a trouble to configure the CISCO radio Air sap 2602, I need make a link between 2 radios, but I can't use like a repeater, because I need use the ethernet port, can I put a radio like access point and another like a client? if yes, how...

Hello Experts !Autonomous access point :- I have came across an issue where client is showing connected to SSID, even I can see the arp & IP obtained detail in the AP but unable to ping the client IP from the AP. ( happening for many clients, even so...