Wireless

Hi!I have a problem and that is that printers having Bonjour-service feature is randomly detectable by Ipads and Iphones. Their Bonjour-service is not always showing in the WLC either. But if it is, we can use Airprint from a MacBook but not always f...

Hi All,Let me need a conclusion on which i trying to make a solution with cisco WAP,where the AP is broadcasting the signal on 2 radios (2.4/5 GHz) with single SSID eg:test. Whether the WAP having the options to allow only the one radio supported cli...

OK, we were trying to upgrade our wireless facilities in the auto repair shop.  Out on the shop floor we have 4 Panasonic wireless diagnostic workstations that are Win 7 based units on mobile carts that traverse the room.  The touch screen computer c...

hello Support,how to configure auto sync config in CPI? when the customer make a changes in the switches and Routers, the customer expect a new version of the configuration in CPI immediately. but we are getting the new version after 10 minutes. if w...

Is Cisco Prime Assurance Manager included in Prime Infrastructure ...I know it is going EOS.

What Impact will the AP's when we change the hostname of the WLC (Was incorrectly Named).1.  Will we lose connection to the AP's/AP's los3e2.  DNS issues?3.  DHCP issues with the AP's (they are assigned an IP Address and Gateway.4.  Will the devices ...

I keep getting these minor alarms "Load threshold violation 802.11.a/n".  Where are these thresholds defined?  I have Prime 2.1 and 5508 controllers 7.6

Hello All - I read this below lines from Cisco's Flexconnect Configuration guide"You can deploy a FlexConnect access point with either a static IP address or a DHCP address. In the case of DHCP, a DHCP server must be available locally and must be abl...

3602I constantly shows a fast blinking green light, watching the boot up I see the following:Loading "flash:/ap3g2-k9w8-mx.152-2.JA/ap3g2-k9w8-xx.152-2.JA"...uncompress: Unknown mzip segment type: 2Error loading "flash:/ap3g2-k9w8-mx.152-2.JA/ap3g2-k...

hi all, I need to configure a configuration template to find the output of "show cdp neighbor" using Cisco PI and redirect the output to another server like ftp or tftp.please advise 

Dears, I created site map on PI 1.4 and added AP on this map but actually the coverage area it seem horizontal lines not circular shape i edit more than one time in Azimuth and Elevation but the AP still seems as horizontal line how come i get circul...