If you were installing 2702e outdoor with wall mount for a school to have coverage in the areas around the school and also near the wall, would you use an omni AIR-ANT2544V4M-R or directional AIR-ANT2566P4W-R?
If you were installing 2702e outdoor with wall mount for a school to have coverage in the areas around the school and also near the wall, would you use an omni AIR-ANT2544V4M-R or directional AIR-ANT2566P4W-R?
I'm trying to replace a WLAN controller with a new one. One WLAN is configured with WPA-PSK. Nobody seems to know the key that was used.Anyone know if there is a way to extract the encrypted key out of a controller and put it into the new WLAN Con...
Hi, I just tried to connect cisco PI 2.1 to cisco ISE 1.3, but fails.I read the release Notes, only ISE 1.2 ist supported.But I was wondering that the ssl handshake fails (I have done a packet capture). So PI 2.1 has not tried to connect to ise 1.3 v...
Hello, I want activate a vpn license on Cisco 1941WI alredy try to download the license, but when a try to install it on the router, it tell me that license dont work need help about the procedureThanks PS: the license i download is 0 kb
My Contract No is 94424274 , this is for wireless product (AIR SAP1602i -n-k9) ,I cannot download Autonomous IOS for that , Plz tell me the details process to download .
Dears, We want to join 1552e AP to WLC controller:First problem was : Radius Authorization Pending for the AP, i added it MAC to AP filterSecond problem: Regulatory domain check has failed for the AP, Access point shows in cdp as: AIR-CAP1552E-K-K9...
Currently our Guest and employee BYOD clients get dropped on to the same vlan. Guest is an open wlan, and BYOD is doing 802.1X with PEAP. We are wanting to allow access to Apple TV devices for both guest and BYOD clients which are on the same vlan/...
looking into a problem at one of my sites with 49 APs (1242s) using WLC 4402 running 7.0.250.0 all channels are on 1, why is this when controlled by the WLC? has the algorithm changed with newer software, please see enclosed for the DCA screenshot, D...
Hi Team, I have a customer that has APs that are connected off a Switch and this switch has uplinks to two 3850 wlcs. So the APs are not directly connected to the 3850s but are connected to a switch and vlan that does connect back to the 3850 WLC. ...
Hi,I'm trying to setup a 5508 to put multiple management ports into LAG configuration for Etherchannel to the connected switch. I have not found where to configure that in the GUI. Is that a CLI-only command?Thanks.
In WLC, how do I setup so that AccessPoint-1 (3602i) accepts connection from deviceA and deviceB only, but not deviceC ? Note that other access points, such as AccessPoint-2 still takes connection from deviceA, B and C I am using WLC v8.0Please advis...
I sometime have up to 90 people connected to an AP.I have 3 SSIDs on my APs. 1 of them is the Corporate one and I need people who on that SSID have special treatment and make their network run faster , in the event of congestion. I dont really care a...
We have a wireless controller with 15 access points(AIR-CAP2702i-K9). They were all up & working fine until we had a power outage. After the power came back up, they all came back up but 3 of the access points will not accept any clients. I have re-c...
Hello EveroneI'm using the Cisco Aironet 1140 Access Point.Some clients connecting to the 1140 are being issued IP Addresses in the169.254.0.0 range while others on the same AP are 10.0.0.0 range, which is what they should be. I know Microsoft client...
What I am trying to configure is Mobility Groups.My understanding is that this will allow AP to successfully register and fail over over seamlessly if any of the WLC had to fail ?It could be I am confusing two things into one & I am totally confused...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 10-15-2026 05:58 PM | ||
| 10-12-2026 06:46 PM | ||
| 09-30-2026 07:34 AM | ||
| 08-10-2026 11:32 AM | ||
| 08-06-2026 09:29 PM |
| User | Count |
|---|---|
| 5 | |
| 2 | |
| 1 | |
| 1 | |
| 1 |