Wireless

Hi All, I have to deploy Cisco Flex 7500 WLC with Cisco 1600 series APs at a customer site. There requirement is to map their existing VLANs to only single SSID. They have around 8 VLANs which are created according to the Active Directory Groups for ...

I am starting a upgrade deployment of hundreds of new 2602s, and they are all coming up in mesh/bridge (MAP) mode out of the box.  This is really slowing down the deployment.I have to:- put each AP's MAC in the MAC filter (to pre-authenticate the APs...

Hi,I use a WLC CT 2504 in the office and I have two problems regarding device discovery within the network. I would appreciate if you could help me with these problems.1. I want to see the network devices in the Network panel in Win 7. I can ping all...

Hi AllIm looking to replace our current Air-Cap 3501s with 3502s to ake advantage of the 5Ghz band, we currently run 16 APs over about 22000 sq feet and we have a couple of 5508 controllers.I'm based in an office right in the center of the city hence...

On a WLC 2504, Is the the local radius database the same as PAC (Protected Access Credential) ?

Has anyone tried to use VLAN for HA-SSO RP connection on 5508? Is it possible as VLAN can be used for WiSM−2 WLCs?The deployment guide says: "5500/7500/8500 WLCs have a dedicated Redundancy Port which should be connected back to back inorder to synch...

Hi allWe are trying to configure a C5760 for webauth, but cannot find the place to set the hostname for the Virtual IP address ?As far as we can see there is no mention of this in the configuration guide as well.What should we do ?/Thomas

Hi All, I have worked on WLCs and 1262n lwaps but this is for the first time I am working on WAP121, we forgot the username and password for this box, I just want to check how we can recover the credentials of this WAP.Any help is much appreciated.Th...

Hi,i have 1260 AP (Autonomous) and i want the clients to connect only at 5GHz MCS rates (802.11n) and i dont want clients connecting at 802.11a data rates. i tried to do this from AP GUI but it says i have to enable at least one data rate from 11a. P...

Will the cisco 1230 access point work in lighweight mode if it is using a radio?

Hi Guys,I will need to configure IOS (standalone) 2602E as access point as wireless bridge. When I try to disable 3 out of 4 antenna ports (only enable A) for wireless birding it won’t save I get white screen but if make changes on rest the setting I...

hi, I´ve connected two 1042 Access Points and when they start they say: No Mesh startup file foundand it lasts very long until they connect to each other what´s my problem with this error messageI´m using two 5508 controller in HA mode with AIR-CT550...

Here is the setup. We have a series of 3560 switches acting as layer 3 devices. The campus is subnetted based on location and application. For instance, one building would be say, 10.13.x.x. The interfaces on the switches are configured for either da...