Wireless

         Hii configure Air-ap1252Ag-a-k9 i create ssid but the ssid is not showing in laptop 

Hi all.I have a little question concerning WC 5500 cisco HA.I configured HA with 2 WC 5500.i have one active controller and one standby.But, i can't manage my cluster with GUI.Only by cli.Have you any idea ?Thanks.Thierry.

how i configure wireless lan

In cisco conntroller(4400) how to make access group in the controllers  .   

Hello!We have zero-based installed Prime 1.3 and MSE 7.3.101 virtual appliances on ESXi 5.0.When I add MSE to Prime, on the second step (Licensing) it is seen that MSE license is not activated and there are no evaluation license at all (PI-MSE-licens...

Hello,We are refreshing APs and noticed old model of APs are still consuming license. Is there a way to remove any APs that being offline for a while automatially either from WLC or Prome Infrastructure?   Thanks,Larry

I am looking for a legend for the maps in Prime Infrastructure.  I have found one, but it only has a few items on it.  I have many showing up on my maps along with numbers on the side of them.  Any document to reference would be great. Thanks!

What is the configuration occur to a H-REAP AP once we tick "enable office extend ap" tick box under H-REAP tab ? Does this only give the capability of adding personal SSID or something more ?Rasika

Hello,I've been assigned the task of configuring the WLAN for a new three-floor building. We have a Cisco 2504 wireless controller and a couple of Aironet 2600 access points. Our access switches are 2960-S with PoE. We have diferent VLANs configured ...

Hi All,We have created SSID with 802.1x authentication with WPA2 AES encrytion(Broadcast) . When I am trying to access the SSID in my Android , apple mobile it is directly asking for username and password . And it is getting authenticated .Whereas in...

Hi  , I would like to know the difference between 6500 series WLSM & 6500 series WiSM.& also let me know, how many controllers will be physically inside the 6500 series WiSM.

Hello All,We have a 1240g AP whose signal appears to be flapping.  It is strong one second and the next it is OFF.  We are not losing any pings to it and we have rebooted it and flashed it to the latest autonomous code, but still the signal keeps fla...

please find the attachment . AS i configured on the file   ,  LAP1 register successfully on the controller then i configured two SSID with different subnet . the problem user who try to access the LAP can't gets IP also controller can't ping the gate...

We are having a problem with around 10 Access Points in a hall on one site.It would appear that clients are connecting to a close access point and then being disassociated from it, and connected to another access point that is distant with less signa...

Dear All,in cisco WLC,can we disable certain data rate for specific WLAN/SSID  instead of using global paramaters ???(Wireless > 802.11a/n or 802.11b/g/n >  Network to open the 802.11a (or 802.11b/g) Global Parameters page)