Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Resolved! AIR-ACCRMK1300= Mounting manual
Hi,I need some manual about how to use AIR-ACCRMK1300=.Is there any offical manual?Thanks,Omer Shtivi
Hi all, I facing some issue on wireless connection, problem statement would be as below:When a client connecting to a specific AP (example AP01), after every 1800 sec uptime it will reconnect and join other unit AP (example AP02)Both AP physically in...
I have a Cisco 5508 setup at a host site with 3 other sites connected using hreap on 1252APs. When doing testing of network speed I find that the throughput from the wireless to wired network is at about 18mbps yet the same test on wired side is 85-...
Hi Team,I'm troubleshooting a DHCP issue between a 3500 and a 5508.During the investigations we discovered two error messages one on the controller and the one on the AP.I could not find this error on any of the doco and if someone could elaborate on...
Does anyone know if there's a bug in the code for management over wireless in 7.2.110.0? I have it enabled, but cannot connect to it. When I do a port scan and see ftp and http open - https does not respond. It should be the other way around, with...
Does anyone have experience with setting up the following scenerio? We have an ACS 5.1 server that we would like to use RSAsecure ID tokens with. Followed the config guide but still cant get it working. Any methodology to test if the two are even c...
Hi I have one question about WLC.WLC can perform DHCP request load balancing between primary and secondary external DHCP servers.If not please let me know what would be best way to use both servers equally.Thanks Nomi
Hi, I am all new to this. I have a stand alone 1140 AP and i am trying to perform a site survey using the AP; However I dont know what configs need to be on the AP for the survey ? can you help me please?
guyswhat's the major difference between the regulator domains for access points?http://www.cisco.com/en/US/prod/collateral/wireless/ps5679/ps5861/product_data_sheet0900aecd80537b6a_ps10981_Products_Data_Sheet.htmlFor eg: if I use a N domain access po...
Is it possible to assign a manual DHCP entry on the internal DHCP of a WLC ? I would like to enable wireless printing and avoid having to hardcode the IP address of the wireless print server.
1. Does the Aironet 1242G have an internal antenna?2. When connecting an AIR-ANT1728 omnidirectional to the primary connector on the ap, does this have to be enable or is it enable by default?3. My laptops can connect and travel between access point ...
AIR-ANT2524V4C-R=Is this a directional Patch or a Omni patchCisco's tech spec pdf on this antenna says its Cisco Aironet Four-Element, MIMO, Dual-BandCeiling Mount Omnidirectional Antenna(AIR-ANT2524V4C-R)with no beamwidth stats Cisco's N antenna por...
Dear all,I am little bit confused about cisco 2504 wireless controller, is it support cisco 1552E outdoor access point?If NO please provide me the correct series/model.Advance Thanks,Anwar Hossain
Hi EveryoneWe have a problem.... well... many of them with a 7921G wifi phones. One of them is They are some users inside of pick up groups (all of them with 7921 phones). These pick up groups have configured with sound and visual alerts after 12 se...
HelloCan you please give me enlightment. I have this conclusion:In WLC there are static and dynamic interface right?Static are (Virtual Interface, Management Interface and AP manager)and dynamic are (dynamic interface for Wireless VLAN and dynamic AP...
