Wireless

- How can I set the power local to more than 12? I am only can set my power local to 12 or Max however I can see it is available for 12, 18, 21, 23 ,,,,,- I run show controllers dot11Radio 0, it shows the current power is 0. Any ideas?

Hi,i need that wlc lets only one session login for user, it means if someone use auth data, user: john, password: cisco123 and another person knows this same information, the wlc doesn´t let that he or she is connect to network because it there is al...

When surveying with Airmagnet Survey, I've noticed my interference levels are extremely high when doing a passive survey, and very low during an active survey. I can assume this is because the card can only listen on the associated channel during an ...

When I view web page of 1410 radio is show ethernet enabled and up but radio as disabled and down. I have tried to enable but to no avail. Is this a sign my radio has gone bad?

Guys,I have a gym in a school that needs wireless coverage. I have 1242 APs and 1522 outdoor.It was suggested to use one outdoor AP inside the gym rather than using indoor one.I am not sure if there are any recommendations about putting outdoor AP's ...

hi,  i see there is an option to "allow password change" or "force password change" for guest roles in the NGS. But when i created a guest account using this guest role, after webauthentication , there is no prompt to change password. Is this the int...

i have a controller that has mutliple dhcp scopes and should in theory give out close to a thousand plus addresses. But i have seen wireless users not getting addresses once the controller has leased about 490 ip adds.  anyone see anything like this ...

Hello world,I have the following situation:One WLC 2000 Series (software version 7.0.230.0) with multiple SSID`s, one is with 802.1x integrated with a Radius Server.Everything worked fine until fiew days ago, when users were unable to logon via they`...

Hi,I have very strange issue with my wireless Lan controller. It reboots automatically.Atleast in week, it restarts once or twice. If i want to check any historical logs , i can not check since after restarting WLC , all logs will be cleared, I get t...

Is posible stop sending of accounting-interim register in a Catalyst 6500 Series/7600 Series Wireless Services Module (WiSM) version 4.1.185.0 ??

Is their a comprehensive guide on the steps required to add a new, unconfigured WLC to Cisco Prime NCS? I've found bits and pieces of info on Cisco's site but I haven't been able to find that one guide that details the process from start to finish.Cu...

Dear All,I'm having problem with windows sharing (file/printer sharing) from Wireless lan client which is connected to AP3500 andWLC 5508 then to Nexus 7010. It's already using ip command, for example \\192.168.84.65WLC os version 7.0.116.0 (using AP...