Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hello,I am trying to get this officeextend working.I connected the ap and checked the H-Reap box and then officeextend and gave it a public ip. This public ip is NAT'd to the dmz controller on the firewall. (The dmz controller is 5508 running code 6....

How can I have access to the cisco "AP#" prompt?When I try to acees the AP through hyperterminal, it gives me the attached messages. The message keeps looping and not letting me access the AP# command prompt to assign an IP address so that I can cont...

Legust321 by Community Member
  • 1230 Views
  • 2 replies
  • 0 Helpful votes

Resolved! AP over internet

We have two WLC 5508 and i want to know if it is possible to get an accesspoint ( eg. 1131) to connect to a controller over internet, without VPN-connection. I have read documents about HREAP but that needs, if I understands it correcly, a VPN tunnel...

s.hellman by Level 4
  • 1391 Views
  • 2 replies
  • 0 Helpful votes

Hello,Is anyone aware of a way, "except for not broadcasting the SSID", to prevent clients from Inadvertently obtaining an IP address on a guest wireless network?We are using two pair of 5508's for anchor controllers, and we're close to reaching our ...

shane.clark2 by Community Member
  • 2358 Views
  • 7 replies
  • 0 Helpful votes

I am currently using a 5508 controller with 25 1142N AP's, I am using one WLAN with LDAP authentication against our dc's and one WLAN is open with guest access only. All is working well.My question is can I create a 3rd WLAN using the the same authen...

dclee by Level 5
  • 976 Views
  • 2 replies
  • 0 Helpful votes

Curious as the range of the AIR-LAP1142N-A-K9 access point ? Also has anyone mounted these above the ceiling tiles in an office space..To keep them out of view I had them mounted above the ceiling tiles and dont seem to be getting the best performanc...

dclee by Level 5
  • 4134 Views
  • 9 replies
  • 0 Helpful votes

I'm configuring an 1140 and trying to make it invisable to any user that doesnt know the SSID. The SSID is not broadcast, however my clients see "Other Network" in their list of available networks. Short of turning off the AP is there any way through...

s.hoskins by Community Member
  • 1146 Views
  • 2 replies
  • 0 Helpful votes

Hi allquesiton:  if I have WLC in sydney and a  LAP in Singapore, for two laptop via LAP to share the data in Signapore office, the traffic has to go to sydney first then travelling back to back to Singapore. is that correct? if so is there any other...

Hi All,I'm trying to download firmware for my 1252 access point.  When I browse to the proper location (http://www.cisco.com/cisco/software/type.html?mdfid=281235915&flowid=6779), there are two choices (IOS software and Lightweight IOS software).  Ho...

My 5508 WLC is set up with a Guest wireless WLANIt is my understading that Guest access only allows http and https, and that machines authenticated to this WLAN should not be able to access normal network resources, or even ping.Is this correct? Is t...