Wireless

I have about 10 Cisco 1200s.  They are spaced out pretty well throughout my building.  There does not seem to be that many dead spots that I have noticed.  My question is about clients accessing the APs.  We have nearly 175 computers on a one time.  ...

HiWe have recently upgraded the software on our two WLC 4404 from software release 4.0.xxx to 4.2.xxx to  6.1.199.4 and lastly to version 7.0.98.0.We could access the WLC's GUI's using https when it was on version 4.0.xxx. When we did the upgrades fr...

I have a tale of woe for you who may be considering Hybrid REAP with local switching.My client has a varied configuration, but the requirements basically screamed HREAP with local switching.  They have 15 sites, had already purchased a single WLC 440...

a customer has wireless LAN controller with version 4.2.205.0 and i want to upgrade it to version 7.do i need to upgrade the controller to intermediate version or i cant directly upgrade it.

I was using Document 100787 as a guide.1. I have  1252 & 1142 AP's  connected to the Wism (6.0.188.0 code)2.  FWSM I have a 4402 (6.0.188.0 ) appliance connected as my anchor.3. ACS is ver 4.2All of my wireless networks function as expected. I see th...

I need to bridge from our office to our shop that is around 800 feet away.  Here are the DetailsI need the 2.4 ghz antenna for client access (Iphones are not compatiable with 802.11a)The locations are 800 feet away but are line of sight.I need to use...

I have a 2125 WLC. I have some 1242 Access Point registered to the WLC. The problem is that the handheld connects to the WLC but sometimes it shows that it has lost wireless signal. Users say that this happens when they go from one site to another. I...

I currently have DCHP server set up on my new 1141N. Everything works great, but I wanted to know if it were possible to make the DHCP server only hand out ip addresses on the wireless connection? Currently the AP is giving out ip addresses from the ...

Hi, We Have a WLC-4402 controller with LWAPPs and different VLANs and SSIDs. I've configured a Linksys WET200 to associate to one of the SSIDs.On the WLC I can see, that the WET200 is associated to one Wlan.Then I connect one computer with a static I...

Wireless Client 10.150.0.12 pings 172.16.50.100 (Windows 2003 Server with dual NICs on same subnet, same default gateway), reply is from 172.16.50.101, will the WLC drop the return traffic to 10.150.0.12?We notice wireless clients can't ping this dua...

Hello,I have a problema that is driving me crazy, I have a Cisco WLC 2106 with 4 Access Points Attached to it, and my network goes crazy some times, here is an example of a PING to my ASA from a Wireless station:PING 192.168.1.1 (192.168.1.1): 56 dat...

I'm wondering if I am understanding this correctly.  If I place a 3502 in sniffer mode, reboot, and assign the channels I want to sniff, and configure the Wireshark host IP, does the access point act as a promiscuous WLAN adapter?Thanks in advance!

I have some users getting new laptops that thave a Dell DW1501 half card adapter that is giving me problems connecting to the wireless.  Runnning 7.0.116 on the WLC and 1252 APs.  Using WPA2-PSK and the clients show they are associated and authentica...