Wireless

We have a customer who wants a wireless bridge/mesh link between two buildings. They want as much throughput as possible, better than 802.11b/g 54Mb for preference. We've identified Cisoc 1552E or I APs as suitable devices but we can't tell from the ...

I have a wlan with web authentication and I want to use two vlan, one for the users that are trying to authenticate and I want to pass the users to another vlan when the users will be authenticated.Thanks,

we have a 1310 connecting two buildings networks.inside each building we have a wireless network (Intermec access points).we are implementing WEP on the Intermec AP's.will the cisco 1310 allow the wep traffic without interference? or would i need to ...

I have 3 1142N AP's.  I plugged them in one at a time here at my desk and they work fine.  When I take them upstairs and install them only one of them works.  I can move the working one to the other locations and it still works.  The LED flashes cont...

HI guysHope you wellI have a problem with a site, simple problem but becoming an issue.I have to change the ip address or the lwapp1142 to static  but it refuses to take the ip address and keeps getting the Dhcp address.The address i would like it to...

I have a MSE and two WLC's.  The MSE and WLC are connected to the same distribution switch, one physical port away from each other.  The WLC is a trunk port, allowing VLAN 101 (managment VLAN/subnet) and the MSE is an Access port on VLAN 101.I notice...

With Jeevan Patil Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to ask how to consolidate your Wireless Branch Network Cisco subject matter expert Jeevan Patil. Mr. Jeevan Patil is a product manager for th...

Hi,We have an Cisco wireless LAN controller 4400 in our organization, and lots of guest using our Wi-Fi network. I would like to configure a warning and terms and condition page when guest using first time our network.Can you please let me know is th...

Can I Deployed a wireless mesh w/o WCS? is it necessary? I  have 5 1550 AP, WLC (12 AP license) and 1 Catalyst Switch. With all these can I Install a wireless mesh.Thanks

Hi Guys,Trying to get an lightweight AP to register with a controller, never seen this one before where the Discovery request is going out to the controller, the discovery response is coming back, but then nothing. At this point the AP should then se...

Hi NG,i'm currently trying to configure a AP801AGN-E-K9 sitting within a 892W router.it was working previously with the following config, i just don't find it!!!service-module wlan-ap 0 bootimage unifiedinterface Loopback0ip vrf forwarding XXXip addr...