Wireless

I have a question on Point-to-Multipoint Bridging for aironet 1300's.Here is the setup that I have: I have three mobile units that I need to connect to eachother. Each unit has a 1300 series bridge in it, one set as a root, the other 2 as non-root. T...

Hi,We're having issues getting a wlan bridge "linksys wet610n" to work with cisco wlc's.anybody else seen issues with this kind of setup?i believe it has something to do with the fact that mulitple ip's get associated with one mac-address.If we conne...

    Dear Folks,          I have 4400 series controller, in which I have installed 6.0 firmware recently. I could see that 'down ' access points are not displayed in the controller. And also , even if the access points are up, the total number of acti...

Hi all,I have cisco layer 3 and layer 2 switches  in my home lab.now i wanted to learn about cisco wireless.can some tell me which Wireless Access point ot Lan controllers i can buy to begin withOr is there any Lan controller which is less expensive ...

We recently added cleanair to our wireless deployment and I would like to build some snmp templates for Cacti in order to graph some clean-air stats under Cacti.   Yes, I know that WCS has graphing for this, but Cacti provides longer trending, thresh...

Gday Everyone,Been getting this error a lot recently, but have not found much help. Any ideas,*DHCP Client Task: : %DHCP-3-BIND_SRPORT_ERR: dhcp_support.c:376 Binding service port failed.*apfProbeThread: : %LOG-3-Q_IND: passwd_store.c:470 Cannot retr...

We have an issue with the time setting in the GUI of the WCS. The box is set with the right time but in the web interface, the time is 5h in advance.I noticed this while creating a guest user acct, while editing time settings. The controller is not 5...

I have a pair of new WAP4410N and they seem to be suffering from the problem others have reported with loosing connectivity after about a day. I have upgraded to the latest firmware (2.0.3.3) but it is still happening.  In addition, the web interface...

hi, all, happy new year! got a question here.I have a testbed with one WDS AP and two infrastructure APs, both infrastructure ones are registered with WDS AP via wlccp correctly, I can also associate wireless client using LEAP+CCKM on either of them,...

Hi,We've a redundant WLC with 5.0.148 Release and all was working great with both 1242AG and 1131AG LAP until... we decided to use 1131G LAP!!!I've tried to upgrade to 5.1 Release but no way the symptom is still present and it start create me some bi...

I have setup a wired and wireless multicast network and after doing some basic testing, I am happy with the fact that wired users can source IPmc traffic and wireless users can receive it.I then tried the reverse, (wireless source to wired receiver) ...

Hi,I have multiple WiSM's connected on the 6509 switch, sh wism stat will show me the all 4 management IP's, (two slots were powered on)I am able to connect 1st controller GUI and do all my configurations, but when I try to use GUI other management I...