Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hey,I have a Air-AP1141N-A-K9 and I want to set it up as a repeater bridge. I have the web interface up already. I was wondering how to set it up as a repeater for my primary router. I think it only supports 2.4 GhzThe IP for my primary router is192....
Hi,I have whole cisco wireless setup. I have Cisco 1242 AG access points. I am trying to connect my Lenovo laptop which is having Realtek lan drivers but whenever i connects to the wireless it gets disconnected on regular basis. plz helpRegards,Pras...
I've hit uppon a problem and I think its due to a change in the code between 6.0.x and 7.0.x versions of code.We've got a large campus which is a mixture of hospital buildings and university buildings, the university buildings have a separate wireles...
Why does my wrt160nl drop so much speed after a few hours. Last night after having shut off and on the router: 63 Mbit/s. This morning: 36. Turned off and on again and now: 71.What is the problem? What can I do?I have 100 Mbit fiber to the apartment....
I am running into a problem with Vocera smartphones where they appear to be functioning fine but intermittently go into a Searching For Gateway on the readout and the logs show a deauth being sent from the controller. I have been running some logs f...
Trying to configure the guest access however I'm not liking the web authentication features that are available, I must be missing something. Here is what I want to accomplish:1- Users connect to the wireless network using WPA 2 (Which I have configu...
What would be the best antennae solution for our new Aironet 1250. Our office is a clinical environment, 9' drop ceiling and needing coverage for a radius of 90'. Plenty of room above dropped ceiling, fyi.Thanks,Brian
We're currently servicing ~1000 clients between a pair of WiSM modules, hosted inside a single C6K, living inside a single /21 (10.10.176.0/22). We would like to service more clients ... we're guessing another ~500 or so, perhaps more, as time pr...
Hello,I need to know what are the implications of getting both radios enabled in the same network? Since I've seen most of the deployments working only on 802.11G but at the same time I have read that 802.11A is "better".If there is a good document t...
I have tried to create and apply an Access Control List on my Wireless Lan Controller but it can't work.My requirement is all the Guests that use Mynetwork by Wifi, they just:using the WEB sevices only.chating by Yahoo only.My configuration as below:...
I have one ssid called eduroamtest using WPA2 PEAP/MSCHAPv2. The ssid is associated to vlan 333.It's a production network with 15k+ clients.I changed my upstream certification authority, so I've to force people changing their client configuration and...
hi,i have a client who allready implemented WLAN System with Cisco 4402 Controller and 1242 Access Points, now the controller's AP limit is full as it is maximum will support of 50 APs. now cleint doesn't want to invest more money with IT budget, so ...
hi,VIOP over WLAN will work with Autonomous AP Environment ??? if yes is there any limitation ?thanks,Anvar
Hi All,I am facing issue configuring wpa2 on the AP. My AP is 1231G with AIR-MP21G Radio.When i try to configure I get the error as Invalid input detected.1231GAP(Config-ssid)#authentication key-management wpa2 ...
How to add 50 nos of 1142 APs in 3750G controlller.
