Wireless

I will be staging Cisco 1522 outdoor AP in our LAB and I need a RF terminator for the 2.4GHz and 5 GHz antenna.On my recent training, the instructor mentioned using a RF terminator when staging the Cisco 1522.I searched the internet and found this sp...

We stuck with dealing with RIAA complaints; and we need a better way of correlating MAC address to Client ID.We are using 802.1x, and we can  (and have) run the client association report  on the WCS, but that is very time consuming.I was hoping to be...

Hello,Can an AIR-LAP1142N be setup for vty access with tacacs+ authentication via command line on the AP?  or does this have to be done on the WLC?  This would be strictly for network administration of the ap not for granting access to wireless clien...

Hi All,I am going setup a wireless project for a hotel.So, what kind of AP should I use to for indoor and out door?May I use 1310 for Outdoor? and 1240 or 1200 for indoor?By the way, may I use Root-brigde with client (Non-root-brigde with client) in ...

I have 2 1130's and 1 1240 that I am trying to configure locally switching on.  The 1240 seems fine.  But the 1130's, when ever I put them in h-reap mode, when the APs come back up and re-join the controller, the radios report they are administrative...

Hi I need help in designing a WLAN solution where we have two buildings and both are connected via CORE switch. Both the buildings are on different VTP domains. Our WLC 5508 will be in one building and Clients /LAPs on other building. We are using 3 ...

Hi everybody,How can I reduce the roaming of my wireless ip phone that's taking a lot of time, without ACS and without controller.Thank you.

We have converted a WLSE 1130 to WCS but everytime we upgrade, the appliance poweroff during "Migrating Data...". If we try to install a new version and restore a database backup from a previous version the same thing happens. How can we figure out w...

HiWe have WLC 5508 and setting the RSA radius authentication 7.1when we are trying to authenticate with RSA it fails so not sure whats doing that.any help would be appreciatedthanksAsif

Hello, recently bought a wusb600n but i notice that i'm getting "poor" signals from it while my previous wusb54g was getting "very good" singals. Already tried configuring my router but the results were still the same. Any ideas?

How do I setup the password on the WEP enabled WAP4410n? When I run the AP in open mode it runs fine but I want to make it secure it requires a password and I haven't a clue where to set it up.Regards,Greg (a newbe to networks and wireless networks)

New to Cisco WCS, i.e. fresh install.  We have a new install of v7.x WCS, with three admins.  Didn't find any reference to this issue in the Cisco docs/search.  Question/Statement is: If two users are logged in and making modifications to the same ca...

I am trying to use WCS Calibration and collecting data points using my tablet. I am having a problem where over 80% of the time it says "No data points collected starting from location (x,y)" However, if I stand in that same exact spot and do it enou...

Hi,I have 60 APs mod.LAP1142 with .n standard enabled.I have the necessary to install a new AP in outdoor area and I have ne LAP1252.Is possible to disable the .n functionality for only this AP and can I use one directional antenna NON MIMO?Ragards.M...