Wireless

Hello to all,I have a 2125 wlc controller, i want that the controller serves the IP address to the AP's and i perform the next configuration:I have configured a DHCP range on my controller for the subnet of the AP's, i have configured in the AP-manag...

Hi guys,i have a question for you:scenario:zone 1 use 802.11 azone 2 use 802.11 bzone 1 and 2 adjacent and overlap also in the border lineIf I configure 2 voice WLAN with the same parameters( security, auth mode etc) will a phone going from zone 1 to...

I have set up an 1131 AP for OEAP.  Everything is configured coeectly on the Controller, AP, and firewall.  I take the AP home and connect it to my network.  The AP connects to the controller as expected and broadcasts the WLAN's.So that all appears ...

Hi all,We have UCM 7.1.3 installed for several months by now. We use hunt-groups for incoming calls to our service desk, if there is a phone ringing we were able to make a group pickup by all our phones to take over the call. Since yesterday this isn...

I have two WiSM line cards (4 controllers) along with a WCS. I tried to do a fresh on all of the controllers. Two of the controllers on the same WiSM returned the following status on the refresh:Refresh succeeded but some records were dropped because...

Good morning,Anybody could me refer to some documentation about how clients ccx and ccx v3 connect to aps in h-reap mode and roaming with security psk or peap?thnks allFran

is there a posibility to control an AP's signal to stop or decrease when nobody is join in? The AP is a Cisco Aironet 1131AG and is plugged in a controller Cisco WLC 2100 series. So I want to know is if there are any configurable option to do this ei...

Hello,I get in touch with you for the following reason, I have a WCS platform mounted with version 6.0.170, I added the WCS autonomous AP, I would like to know if I select a customer who is registered to the AP I get the no autonomous history of asso...

I refer to the usage of Diversity antennas (AIR-ANT2465P-R) on a single LAP1242AG access point.We are trying to cover two different cell locations. Can we use 2 physical different Diversity antennas (same model) on a single AP that is running on b/g ...

Hello,We are using wired and Wireless guest access with an Anchor Controller installed in a DMZ. The Wireless guest accessworks fine but it's not the case for the wired access. The client doesn't receive an IP address. A debug client x.x.x.xshows :*M...

     Does anyone know of a cisco or 3rd party dust enclosure for the Aironet 1141?Thanks

If the guest user account is  created in WCS with life time more than 30 days.But in WLC,the maximum life time for a guest  user is 30 days.If so,will the guest user account be expired after 30 days ?Thanks in advance for the help

We have a WISM in our Cat6509 switch. We created a CSR and then downloaded the device certificate and intermediate certificate and root certificates from GoDaddy. Then following the Cisco documentation we chained the certificates together and then us...

Dear Sir,        I need to configure accesspoint 1140 in my local lan. I have 5 vlans in my network.when i configure all ssid and vlan in 1140 i am unable to ping from 1140 to my other vlans except that vlan which are assign to ssid.  from other vlan...

HelloI have 30 access points with 2 WLC 4402 each one connected to 6506 by just 1 link,as 4402 support 25 access points ,what can i do in this situation?1)do i assign 15 access point to each WLC?e.g 15 LWAP per controller?or what?2) is it recomnded t...