Wireless

Hi,we are testing a setup for a residential building. The owner wants to provide internet to the renters. The owner does not want the clients to see or access each other. Right now, the test setup is something like this: Internet -> 871 -> Cisco swit...

New 7921 authenticates and associates with AP350 (evident in AP350 logs)AP350 is set up for WEP, Full Encryption, Accept Open authentication.7921 is set as 802.11 Mode: auto 802.11a preferred..., security mode : open + WEP, obtain IP and TFTP automat...

I have to create Mesh connection in Campus. So I am planning to use 1524 as a outdoor Mesh bridge with 5508 as Wireless Lan Controller and for indoor I will be planning to use 1140. Can anybody tell me that this solution is correct or not ?Thanks and...

Does the 4404 100 AP lan controller come  with the WCS software, or is that a seperate purchase?How does this lan controller failover?  Does a backup controller need to be purchased?Thank you!

Hi all,Is there any way of doing ip accounting on the guest anchor controller to see which IP/mac is generating the most "bytes" in a 1 minute interval for example ?regards,Geert

Hi everyone,We are using multiple AIR-LAP1242G-E-K9 access points with single 4402 WLAN controller with one of our customers. Here is the detailed info :- WLAN management (192.168.1.51) and ap-manager IP's (192.168.1.50) are on same subnet & VLAN 12-...

issue/challenge where just the radio being down on an AP will not flag an error in wcs...because the AP can be pinged. shouldn't wcs give an alarm for bad radio?

Hi people,I configured an aironet 1200 but when I tried connected with it the AP doesn´t assing IP to my PC?Any idea?Thanks a lot

Runing the report, "Client Traffic Stream Metrics" and I get this errorThe specified criteria did not match any data for the report.Make sure that the following background tasks are running:1.Traffic Stream Metrics2.Radio PerformanceI checked the bac...

I've got a lot of building registered in the WCS I'm working with. I've now started the process of adding campus maps and would like to place the excisting buildings on that map somehow. Is this possible at all or do you always have to create campus ...

Hi,We have a few customers whose controllers are added to our WCS for monitoring purposes. Now I'm planning to give access to customers on that WCS, so they could also check AP status, clients etc. For obvious reasons, I don't want to Customer01 to s...

If we define a "campus", does that mean that WCS will use the size of the campus in calculations for RSI, Rogues, etc, or is just used as a "grouping" of buildings?We created a campus in WCS when we first purchased the software, but are wondering now...