Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
We want to deploy wireless guest access in our office. We currently use an ASA 5505 for the firewall, UC520 with CE520 switch and 520 APs. We do not have a 526 controller. What I am looking for is a configuration guide of some sorts to implement the ...
Hello,I have wireless network with 2 WLCs and I configured a guest access WLAN with web autentication.I would like to use a LOCAL authentications with lobby ambassador for guest users.Is there a way to create a user only once in one WLC?At the moment...
if i used 1250 as bridge mode can i used Integrated BR1410 Patch Antenna it provide 22.5 dbi gain my clinet request meAntenna :integrated Flate plate 23 dbi
HiExperts can we use 1250/1240 as a wireless bridge and does 1240 support MIMO technologyThanks
WLC (4402 and 2112) running version 6.0.188 is displaying the following error in the msglog.“*Dec 11 15:13:12.185: %USMDB-3-MSGTAG030: usmdb_apf.c:262 For information regarding Emergency image Version,Please refer Controller documents” The solution t...
i need to mak a make on wireless bridge quote following is the specficiationRadio bridge With MIMO technologychannel size 5/10/15/20/40 MHZchannel selection i-DFStrasnmit power -18dbm to 27 dbmSystem Gain up to 167 DB using 23 dBi Integerated A...
I have just upgraded my location appliance and WCS. However, I cannot get the Network Design elements to re-synchronize. Keep getting message "A similar element was found in the Server. Please synchronize again to remove any disparities.". Controlle...
I had created the SSL vpn on cisco 2851 , and created ssl users using local database with privilege 15 ,these users are able to access everything . i want to restrict users to access some sites .can anybody tell me the procedure .Adavnce thanks...Nit...
i am not a newbie to networking. i have done ccna successfully. now i want to do gain some knowledge regarding the security of the networks.i want to know which book i prefer?? or any other good advice..Regards
I have a Cisco ACS version 4.0 and a Wireless Network with a Wireless Lan Controller 4402 version 5.2. The actual WLAN is protected whit WPA but I like to use the local ACS database for user authentication in the wireless network. Is this possible ?R...
We are using motorola canopy SM's and AP's. For distribution to the end user we are using these piece of shit nanostation routers...they have little to no penetration. If we wanted to establish a wifi hotspot within a thickly settled/dense area lik...
hello, im trying to setup wireless interface and already start reading several documents.i would like to ask what the meaning of the BVI interface? Is it nessesery?thanks
Hello,We have some APs (AP1, AP2, etc) with confugured WDS on one AP.On APs configured two SSID with two static assigned VLANs:dot11 ssid K-Internet vlan 3 authentication open authentication key-management wpa mbssid guest-mode wpa-psk asci...
Hi Folks,I have been reading through the design documentation for the Wireless devices, and I can't seem to find a definitive answer to the following:Is it possible to have a centralised WLC (in a DMZ) which controls many remote sites? Each site sh...
All,Is there any way to do a port span or tap of all traffic going to and from a WiSM? You can't seem to monitor the port channel that goes into the controller.ThanksJason
