Wireless

I'm running a WLAN infrastructure dispersed over multiple sites, which all run a local 440x WLC. One site is the main site and runs a backup WLC which can take over any site's APs in case a remote WLC shoud fail.Here's my question: In order for failo...

I am posting here my frustrations with running WCS in a Virtual Machine (VMWare) and just wanted to let everyone know what my issue was and what fixed it. WCS will complain when the memory is below 2.0 GB at the time of installation, but does not sti...

I recently got a pair of outdoor 1310G bridge radios to create a bridge. I upgraded one of the APs from Autonomous to LWAPP so that it could connect to our 4402 controller so that it could be monitored and controlled by it. Everything looks like it u...

Does anybody tried those two phones to use with IP Contact Center Espress 5.0 by IP Phone Agent service?

Hi Guys - I am taking security copies of controller configurations from WLCs. The problem I see is that I get inconsistent file sizes and I wondered if anyone knows what might be causing this and what the "typical" file size would be?Two controllers ...

Good morning,my customer has an area covered by 3 AP and all the 26 users are joined to only ONE AP. Is there any option to force the client to distribute across different AP. Customer is using WLC and WCS in a LWAPP environment.I thought the only cr...

Hello,I have a problem with Aironet 1300 to provide the repeater mode to PT-link TL-WA601G for extending the signal.I have two cisco aironet, i have configures as the bridge to link each other and WEP 128bit key.Then i bought TL-WA601G for extending ...

Hi all,Im applying redundancy to the wireless network by assigning an Active and a Backup port to each VLAN. when the active port goes down the VLAN transfers to the backup port. The issue is when the first link goes up again the VLAN does not return...

I have a very strange customer requirements to provide a outdoor solution with "fixed ruggedized outdoor" APs that support 802.11n in addition he will be very pleased of a MESH deployment. The only Cisco 802.11n AP I see is 1252, which placed in a ou...

I have a client having issues with connectivity. I see the user connecting at a and b to the same access point. how can i avoid this? i have found this by running a report on the WCS. I have several floors and several AP's and do RRM to determine tx ...

I am using two autonomous 1242's to bridge two wired networks (one AP is root, the other is non-root, no user wireless clients are supported). In this configuration, aren't the AP's bridging at the Layer 2 level (that's what bridges do, right)? From ...

I was trying to update the firmware on my 1200, and now it says "The system is unable to boot automatically because thereare no bootable files to boot.it sits at a "ap:" prompt and will not allow me to enter "enable" mode. HELP!

We have made the AP as the WDS server and the issue we are facing is the AP count is getting increased like anything, were as I only have 10 AP in my network but AP count gets increased to 20 to 30 and after 32 the APs which had registered will get d...

I'm trying to configure our WiSM (and other WLC's) to use a timeout other than the default for the device class "unknown". I've been able to find the command for stand alone access points which is [config dot11 activity-timeout unknown default {secon...