Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I have added all switches in the network into WCS with snmp version 2c read only.When I try to trace one of rogue AP that I have connected into one of switch, the WCS return with an error message shown as below:"2009/04/14 20:02:34 Switch port trace ...

chaijoo_lau by • Frequent Visitor
  • 1490 Views
  • 2 replies
  • 0 Helpful votes

wlc

I found this in a cisco 1300 datasheet.---------------------------------------------------------------------------|AIR-ANT2414S-R* Cisco Aironet 2.4-GHz, 14-dBi sector antenna. |------------------------------------------------------------------------...

This may be a simple fix and any suggestions would be appreciated.We have a hospital network, using Cisco 1200 series AP. We have plenty of AP coverage, signal strength stays excellent. The issue is we are beginning to run our main database system wi...

karafowler by • Community Member
  • 503 Views
  • 1 replies
  • 0 Helpful votes

Hi,I am using 5.2 WCS as the migration tool. The Autonomous APs have their IP addresses statically configured. I am using DNS to resolve the controller name.The AP resolves the controller AP then does nothing with it. It just starts broadcasting for ...

I have an aironet 1252 access point and I have it set up with 3 ssid's which in turn are 3 separate vlans. My question is, can the 1250 supply dhcp to each ssid or only to the native vlan. This access point is going to be connected to a 4507 routing ...

Currently we have 2 WISMs that handle approximately 100 AP's. We are looking to replace our 1242 AP's with the new N 1142's. I was wondering how many clients these 1142's can support compared to the 1242's? Most of our company laptops do not have N c...

vancamt76 by • Level 2
  • 920 Views
  • 4 replies
  • 0 Helpful votes

Good morning! I hope that there is a Cisco wireless specialist able to help me. First question: I know that the 802.11a frequencies supported by 1240AG Access Points are: 2,412 to 2,472 GHz (13 channels) 5,15 to 5,35 GHz (8 channels) 5,470 to 5,725 M...

ASF_SVI_ITE by • Community Member
  • 1377 Views
  • 6 replies
  • 0 Helpful votes

Good morning! I hope that there is a Cisco wireless specialist able to help me. First question: I know that the 802.11a frequencies supported by 1240AG Access Points are: 2,412 to 2,472 GHz (13 channels)5,15 to 5,35 GHz (8 channels)5,470 to 5,725 MHz...

ASF_SVI_ITE by • Community Member
  • 550 Views
  • 1 replies
  • 0 Helpful votes

Hi,I have a situation where I have 3 building that are over 1000 ft apart and have no wired solution we can plug into (and no line of site) for sharing files. Does Cisco provide a wireless Internet hardware solution where 3 buildings can share files ...

Fisrt of all, thanks everybody.I'have been facing a problem of lost of connectivit at ethernet interface.I'm using 2 Aironet 1310 as bridge between 2 buildings. The wireless configuration is OK.It is an intermmitent problem. Sometimes all computers a...

Review Cisco Networking for a $25 gift card