Wireless

I have two 1131AG with one configured as a Root AP and another as a WGB. Everything is working great except passing multicast traffic between the two. Any one know why? Thanks,Steve

I'm looking for a way for a server to remotely add MAC addresses to the filter on a Cisco 4400 wireless controller. Normally, I would just have the server connect to the controller via SSH, but I don't know how to write a script to deal with the cont...

Hello mates!I've got a strange issue that I haven't encountered before. What's happening is a particular ssid allows an association, but will not provide a dhcp address. Now, I have another ssid on the same controller, pointing to the same dhcp serve...

I'm having trouble with Apple products connecting to a Aironet 1231 using WEP. Apple products seem to complete the association process:*May 26 17:01:23.647: %DOT11-6-ASSOC: Interface Dot11Radio0, Station 001e.5271.1890 Associated KEY_MGMT[NONE]But ne...

Hi everyone,I try to figure out, how much throughput is used by beacons, when using different data rates. It has no practical reason - I just want to understand the theory.I understand, that beacon frames are sent at the lowest configured data-rate. ...

Hi,Hope this sounds familiar to someone.My conrollers run with snmp v3 user only, and seem to lose their snmpsettings after a reload of the controller.Does anyone experience the same here, and is there a solution to this annoying problem?thanx in adv...

Hi all , newbie here i am trying to set up a 2811 which will act as a wireless router with ap card and have nm-cue installed for voicemail etc ..for outgoing i would like one going number ( vic-fxo ) and one sip option .. still working on details ..c...

We have tried to upgrade two Wism from version 5.1.151.0. to 5.2.178.0.At the first Controller the FTP transfer of the new SW was successful, but at thesecond Controller the FTP transfer didn't start.Following error message appears: “At least one A...

I want to enable PSPF in my wlan to prevent communication between wifi clients. You can do that on the access point, but it only has effect on the clients connected to this AP. So if you have a big wifi network, the clients connected to different AP'...

I have a couple of questions. First, if I have aggressive load balancing enabled on the WLC(4400) and the client window set to 0, does that mean it will automatically load balance or does that mean it won't load balance at all regardless whether or n...

I am currently running WCS version 5.2.110.0, and i am having problem with map. The map it self is ok but when i add AP heatmap it all gets unclear. Anyone who have an solution ?

Hello,we've a Cisco WLC 5.2 and implemented MAC-Authentication by using the Cisco ACS. The WLAN's a configured with WPA2-AES and PSK. So, my question is - how secure is this constelation? If not, how can i increase the security by using MAC-Filter/Ci...

hi everyone,please help me,i have a problem with cisco autonomous:Product/Model Number: AIR-AP1131AG-E-K9 System Software Filename: c1130-k9w7-tar.124-10b.JA System Software Version: 12.4(10b)JA Bootloader Version: 12.3(8)JEA the problem is that my a...

Hi, We are planning to implement an outdoor wireless mesh network with 1510 LAP, WLC and WCS. There is also going to be an indoor wireless solution with 1200 AP or 1140 AP. We cannot afford to have the indoor AP wired to the network, because of the b...