Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Insider User Research program

Labels

Forum Posts

Hi,we have the following implementation:Cisco Access Points mainly 1200 series, Cisco ACS v.3.3, and MS Active Directory.I've

jorge.s by Level 1
  • 448 Views
  • 2 replies
  • 0 Helpful votes

Hi,I seem to be getting a 5sec audio delay with peer-to-peer conversations ? at first you answer "hello" wait a few secs then hear them saynig "hello" and then your eventually connected ?what could this be, i have ample signal strenghmany thanks

meggerman by Level 1
  • 878 Views
  • 6 replies
  • 0 Helpful votes

Dear all,We have recently decided to enable WLAN for guest users that authenticates users by redirection to WLC's virtual address (1.1.1.1).I have created WLAN and assigned management interface for it on WLC.Interface points to dhcp server that resid...

augul by Level 1
  • 683 Views
  • 2 replies
  • 0 Helpful votes

Hello,We have 2 4402 WLC's, the second one is configured as fail over.We are creating guest accounts on primary WLC. How do we use the guest account during fail over to second WLC ? (of course without configuring the guest accounts on both controller...

ajber by Level 1
  • 411 Views
  • 1 replies
  • 0 Helpful votes

I just fired up a new 2821 ISR with an NME-AIR-WLC12-K9 in slot 1. Problem is, I can't see the controller. Neither sh hard nor sh run show any indication that the controller is present. What stupid little thing am I missing?Router is running c2800...

2100 wireless lan controller1130 AP's in H-Reap modeStatic WEP and Web AuthenticationThe problem is when clients, who are connected and authenticated reboot their machines, it is not necessary for them to login to the webauth page again. This brings ...

acomiskey by Level 10
  • 593 Views
  • 5 replies
  • 0 Helpful votes

I want to completely factory default the config. of an LAP.It happens to be a 1242AG.I configured these values at Console of the LAP,IP addr, mask, name, WLC IP.It LWAPP Joined successfully to the WLC.From the WLC CLI I did,clear ap (rest of syntax I...

I have been converted our APs over to the 4402 LWAPP controller with little problems, untill I tried converted a newer 1240 AP. The upgrade utility ran fine, but the AP will not register with the controller. The other APs where all 1200 series with S...

I've been looking for an answer for this, probably something simple, just haven't been able to find anything yet. My department has been using Cisco 851w routers in offsite locations, and in some cases would like to have wireless clients to be able t...

adamonis by Level 1
  • 365 Views
  • 1 replies
  • 0 Helpful votes
Unanswered Topics
Review Cisco Networking for a $25 gift card