Wireless

how do you get WCS installed onto the MSE?many thanks

Hi,I run a large wlan. however i have a branch site that requires just 1 cisco accesspoint ( i have a spare 1240g ap ) I would like to make this a standalone AP connected to the lan which can manage client authentication and association. It will be c...

Unable to connect to a Windows Server 2008 NLB Virtual IP Address from hosts via a Cisco wireless environment using WLC4400 and LAP1131AG antennas. When I access the Server through the wired net there is no problem.

Hi All, Has somebody work with adding Autonomous AP to TACACS. I can access the cli mode after I added the same; but I am facing issue with the GUI mode. When I access the GUI mode; the debug says authentication failed.Can somebody help me on the sam...

Hello all,I am seeing regular problems, where a 1242 LAP loses its LWAPP connection to its configured WLC. We use DHCP with the WLC primary and secondary IP addresses in the option 42 bit.Now, the WCS reports it as down. You go to the switchport, and...

HelloI have a requirement to be able to log at least when users log on to the controller (this is to confugure it). If possible I'd like to monitor what they change.Is this possible?Thanks in advance.

I have been trying to upgrade my 1100 series ap.Currently IOS: 12.3(8) JEC2BOOTLDR: 12.2 (4)JAI would like to upgrade a BOOTLDR. What do I need to do?

Have just done an experiment with connecting 2 AP1252 over a 20km distance with the 5ghz radios (Channel 5745).Each site are connected with two 26dbi flat panel antennas with 0,5m pigtails on antenna A and B connectors. The C connector are disabled.T...

I am finding conflicting information on Web Portal Guest Authentication. I would like to confirm that the guest username and passwords are encrypted (via https) between the client and the WLC during the redirect to the Virtual interface (1.1.1.1 in m...

WLC4400 (stand alone) is unreachable because the power is switched off and back randomly.WLC4400 is connected to core switch 3750 and the configuration behind core switch did not change.

We are running WISMS with 4.2.176.0.Our AP's have randomly dissasociating then re-associating the switch port doesn't go down.

do anybody know when Linksys suppose to release the Wireless-N Ethernet Bridge with Dual-Band. I chk w/ Best Buy and they are not sure.

I have a 4404 connected to a 3750G. When I ping from the switch to the controller with anything above 250 byte packet I loose pings. The larger the packet the more loss. I am setup with LAG and have the switch configure to only allow the VLAN's neede...

I have a Cisco 4404 version 4.2.176.0. Once apon a time I had a map function that I had maps drawn up that had the location of the AP with the signal strength colors. A vender came in and think they updated my version and ever since that day it is mi...