Wireless

I will be rolling out the Cisco aironet wireless A/B/G PCMCIA cards to some users soon. The profile setup uses PEAP with MS-CHAP v2 for the authentication process. When the wireless radio is on at the time of booting the laptop, the Cisco software ...

Does anyone knows where i can get access to some online resources for Cisco Wireless products / technology??Would appreciated any help.

Hi all, I have to provide a cisco solution to my customers with the following requirements for the controller/Wireless Switches,1/ 2FastE to Catalyst2950 backbone, at least 6 POE ports2/ support at least 12 managed access points (4AP in 1st Floor; 6A...

Enabling the "Authorize APs against AAA" option in the Wireless LAN Controllers requires you to add the MAC addresses to the ACS server so that the controllers can check the MAC address against RADIUS. If this option is enabled and the MAC addresses ...

I have a WiSM module installed in my 6500 managed by WCS. Iwant to get Lobby Ambassader working but I do not see where I can do that with WCS. Do I have to create a Lobby Ambassader on each controller and then create a username/password on each con...

If you have an area with 40+ wireless users...how can you setup 3 AP's in that area and set it up so that they are somehow load balanced. I'd like to have all 3 AP's sharing the load so to speak.

Hi,Does the GLC-SX-MM applicable at this wireless controller for the distribution ports?Thanks in advanceAbd Alqader

We've upgraded some Cisco Aironet 1100 access points to Firmware Version 12.3(8)JA2. Since the upgrade we've seen several connectivity problems with Dell Axims get cleared up however the event log for each of the access points shows this error messag...

I've got a Cisco Aironet 1200 AIR-AP1231G running IOS v12.3(4)JA.We've had a 128bit WEP encryption scheme setup for a few years and now that we have laptops with Vista on them, they cannot connect at all, even with encryption and authentication turne...

please can someone tell me How can I discover and configure Aironet 1010 lightweight Access Point using 2106 Wireless LAN Controller.thks...

Dear friends,we have a Cisco ACS 4.1 and as long as we worked with EAP-FAST we had no problems. For Security reasons it was decided we switch to PEAP with MS-CHAPv2 for the inner authentication.We installed a PKI Server Certificate on the ACS Server ...

I can't get this to work.http://www.cisco.com/en/US/customer/tech/tk722/tk809/technologies_configuration_example09186a008058f53e.shtmltwo BR1310 bridges, root and non-root.all I get from the non-root is :%DOT11-4-CANT_ASSOC: Interface Dot11Radio0, ca...

Hi,I work for a Container Port operator. I am working on a project to remotely monitor about 70 large cranes in the terminal. Each crane (Quay or RTG) has a LAN on board that connects the PLCs, GPS, Local Computers etc. We also have Terminal wide 802...

hello all,I have figured out how to enable the mac authentication cache on the aironet 1130 from the cli interface but am still dumbfounded on how to set it up in the web interface any help would be appreciated.....thanks