Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi,I have a Cisco 877w router and I'm sure it's not configured correctly by me. If I cable into the router things work fine like the internet and connecting to work etc, however if I wirelessly connect it is never as reliable, it becomes slow etc.Jus...
Does anyone know if the 1500 series which are presently 802.11b/g AP's will be somehow upgradeable to 802.11n AP's. We are very close to putting in a 1.5 square mile mesh system.
Every day at least once and sometimes twice, I have several access points that reboot. They all do it at precisely the same time and it is usually the same AP's - about 8 of them. I have other access points that do not go down.Any ideas? Could this b...
I was told by a wifi tech that the "pipe bomb" antenna [air-ant2506] should be installed upside down when installing inside a building, ie warehouse.When I go to the hardware installation page for the antenna, Cisco makes no statement regarding this....
Hi all, I have a setup whereas I have multiple workgroup bridges with a small switch connected to the ap with 3 pc's on each, these wgb's then associate to an access point. It seems that the connection does not stay alive between them unless we ping ...
Hi, can I make a wireless bridge between a 2142 AP and a 1131 AP?
Current set up is:1 - 4402 - 50ap WLAN Controller with code 4.2.130.01 - 2125- 25ap WLAN controller with code 5.2.15735 - AP1010 access points17 - 1100 series access pointsI've told each access point which controller is its primary controller but aft...
Hi,I have an issue where my new Ap's out of the box in that they are registering with the master controller, upgrading the Lwapp software then rebooting and going through the same upgrade process again and again.Constantly upgrading!!Other AP's that ...
This sounds silly but still i ask to be safe in my project.I want to use Cisco 1250 LAP with wireless controller.I want to use POE facility.There are around 7 1250 seried LAP AP.My question is :01.Suppose the farthest access point (cisco 1250 with wi...
I make a mistake I upgrade my unit AP 1310 to the Lightweight Mode and now nothing work. I need to downgrade to autonomous mode but I have just few command. How can I do this?
Does anyone know of a way to get a WDS access point to send messaged to a Syslog Server?
I am running a home business from my home. I am moving my office to a guest house, approximatrely 150 ft from my exixting linksys router. Signal strength is low to non-existant. I cannot hardwire to the new location. What is the harware solution to k...
Why is it so that I can't put an ACL on the management int or the mangement WLAN. I mean, I can put the ACL on the int/WLAN but it has no effect, it only denies everything. Also, can someone please explain what the difference between putting an ACL o...
I asked a question in regards to this a couple of days ago and, after doing some research, I would like input on the following scenario:2 4402 controllers running 3.2.195.13. 2 new 4404 controllers running 4.2.112. Could I upload the configs on the 4...
Hey all So, I am doing some thruput testng on my wlans, and am getting approx 15M/bit thruput, just using iperf as a bandwdith tool.Is this quite respectible?So, looking at the following Cisco documenthttp://www.cisco.com/en/US/products/hw/wireless/p...
