Wireless

the LAP was reset to default using the mode button. It already has an lwapp image downloaded from the controller on it. I cannot reconfigure it with IP address and controller IP address. Command disabled message is obtained

AP 1130 Model AP's IOS has got corrupted and AP is not booting properly its going in to AP: prompt I have tried to recover the same by following the procedure but unable to recover the same, following is the link is the procedure which I applied http...

Can I configure a 1231 autonomous access-point as a WGB and have it connect to our infrastructure 1030 Series infrastructure APs. I need to get some clients with only ethernet NICs onto our wifi network. If not, anyone have any other ideas short of r...

Hi all, Hope all is well I have a new building with a floor of wireless enabled. Have imported the map and it is on the WCS.Thing is, the view of the map shows that there are no clients associated on any of the APs. When I change the view, it shows a...

We have multiple buildings connected by AP1230B-A-K9's. Due to line of sight we are trying to relay through one building to another. Here's a schematic with nodes numbered for ease of discussion:---Building A---1: LAN Cat52: AP1230 as AP-------------...

Just got this AP, glanced through the guides, fired it up to walk through the setup pages. Seems pretty straight-forward, however, The radio for 802.11g doesn't seem to be working. The radio LED light comes on briefly than goes off - not much of a pa...

Hi TeamWe have a small problem with the AP's for a University in Africa. The 53 Cisco 1252 Access points that were designed are FCC. That means on the WiSM I can't change the country code to ZA because the AP then doesn't report in. If I change it to...

Need clarification - I think it does workDoes the AP Group feature work with the anchor controller guest access featureSSID guest --- LWAP -- LWAPP -- Foreign WLC --- EoIP --- Anchor Controller --- VLAN 10 or VLAN 11ie Guests in Building 1SSID guest ...

I have installed aironet 1300 in 4 farms. the remote APs link to the central AP via one 2.4Gz interface using sectoral antenna and serves the farms on the other 2.4Gz interface using omni antenna. On loading the ERP application at the central farm, t...

We have access points spontaneously jumping between 2 controllers. When this happens, the WLAN associations on the radios are lost. Each time an AP jumps to the other controller, the WLAN is re-assigned to the radio and the configuration is saved. Th...

HelloDoes any one know if an access point (1242) supports downloadable ACL. If so how can I implement it. I am using downloadable ACL for the lan switching and need the same in the wireless LAN.Thanks Victor

Hi,I'm looking for some advice. We need to move some LAP's from one controller to another. There are 2 problems, one is that the LAP's are all in different locations around the country so we cant really get console access and the second is that the o...

Hi,Has anyone actually managed to deploy the AP1252s in dual radio mode and been able to power via a POE device?The information regarding max power supplied is misleading. For example, the 6500 802.3af POE line cards appear to only provide a max of 1...

Cisco Aironet 1240AG Series Access PointC1240 Software Version 12.3(8)JA2We have several of these devices with identical configuration, this is the only one with these problems. Is this a hardware failure?Configured as a Workgroup Bridge"%DOT11-4-CAN...